User manual NETGEAR GS748TR

[. . . ] GS700TR Smart Switch Software Administration Manual NETGEAR, Inc. 4500 Great America Parkway Santa Clara, CA 95054 USA 202-10303-01 May, 2008 © 2007, 2008 by NETGEAR, Inc. FullManual. Technical Support Please refer to the support information card that shipped with your product. By registering your product at http://www. netgear. com/register, we can provide you with faster expert technical support and timely notices of product and software upgrades. [. . . ] Click the Routing > Router Discovery tab. Figure 4-5 4-10 v1. 0, May, 2008 Configuring Routing GS700TR Smart Switch Software Administration Manual Table 4-5. Router Discovery Configuration Fields Field Interface Description Select the router interface for which data is to be configured. To perform the same configuration on all interfaces, select the check box in the heading row. To configure a single interface, select the check box associated with the interface. The interface number appears in the Interface field in the table heading row. Select Enable or Disable from the dropdown menu. If you select Enable, Router Advertisements are transmitted from the selected interface. Enter the IP Address to be used to advertise the router. Enter the maximum time (in seconds) allowed between router advertisements sent from the interface. The allowed range for this field is 4 to 1800. Advertise Mode Advertise Address Maximum Advertise Interval (secs) Minimum Advertise Interval Enter the minimum time (in seconds) allowed between router (secs) advertisements sent from the interface. The allowed range for this field is 3 to 1800. Advertise Lifetime (secs) Enter the value (in seconds) to be used as the lifetime field in router advertisements sent from the interface. This is the maximum length of time that the advertised addresses are to be considered as valid router addresses by hosts. The allowed range for this field is 4 to 9000, i. e. the configured "Maximum Advertise Interval" to 9000. Specify the preference level of the router as a default router relative to other routers on the same subnet. Higher numbered addresses are preferred. You must enter an integer. Preference Level 2. If you make any changes to the page, click Apply to apply the changes to the system. Configuring Routing v1. 0, May, 2008 4-11 GS700TR Smart Switch Software Administration Manual Configuring and Viewing Routes From the Routing Table page, you can configure static and default routes and view the routes that the GS700TR has already learned. Click the Routing > Routing Table tab. Figure 4-6 Table 4-6. Route Configuration Fields Field Route Type Description Specifies whether the route is to be a Default route or a Static route. If creating a default route, all you need to specify is the next hop IP address, otherwise you need to specify each field. [. . . ] For information about how to update or change the system images, see "Dual Image Configuration" on page 8-9. Ping Use the Ping page to tell the switch to send a Ping request to a specified IP address. You can use this feature to check whether the switch can communicate with a particular network host. Click Maintenance > Troubleshooting > Ping in the navigation menu. Figure 8-9 8-12 v1. 0, May, 2008 Maintenance GS700TR Smart Switch Software Administration Manual Table 8-6. Ping Fields Field Hostname/IP Address Description Enter the IP address or the host name of the station you want the switch to ping. [. . . ]