User manual NETGEAR WNAP210

[. . . ] No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of NETGEAR, Inc. technical Support Thank you for choosing NETGEAR. To register your product, get the latest product updates, or get support online, visit us at http://support. Trademarks NETGEAR, the NETGEAR logo, ReadyNAS, ProSafe, Smart Wizard, Auto Uplink, X-RAID2, and NeoTV are trademarks or registered trademarks of NETGEAR, Inc. [. . . ] The Backup Settings screen displays (see the following figure). Your browser extracts the configuration file (the file name is config) from the wireless access point and prompts you for a location on your computer to store the file. Follow the instructions of your browser to save the file. Restore the Configuration IMPORTANT: During the restoration process, do not try to go online, turn off the wireless access point, shut down the computer, or do anything else to the wireless access point until it finishes restarting!To restore your settings from a saved configuration file: 1. During the restoration process, the wireless access point automatically restarts. The restoration process typically takes about 1 minute. When the Test LED turns off, wait a few more seconds before doing anything with the wireless access point. Management | 61 ProSafe Wireless-N Access Point WNAP320 Reference Manual Restore the Wireless Access Point to the Factory Default Settings You can restore the wireless access point to the factory default settings by two methods that are described in the following sections: • • Use the Web Management Interface to Restore Factory Default Settings on this page Use the Reset Button to Restore Factory Default Settings on page 63 Note: After you have restored the factory default settings on the wireless access point: * All custom configurations will be lost. * The Access Point Name field will be reset to the name printed on the label on the bottom of the unit. Use the Web Management Interface to Restore Factory Default Settings IMPORTANT: During the restoration process, do not try to go online, turn off the wireless access point, shut down the computer, or do anything else to the wireless access point until it finishes restarting!To restore the factory default settings using the Web Management Interface: 1. select Maintenance > Reset > Restore Defaults. The Restore Defaults screen displays (see the following figure). Click Apply to reset the wireless access point to the factory default settings. During the restoration process, the wireless access point automatically restarts. The restoration process typically takes about 1 minute. When the Test LED turns off, wait a few more seconds before doing anything with the wireless access point. Use the Reset Button to Restore Factory Default Settings To restore the factory default settings when you do not know the login user name, login password, or IP address, you must use the Reset button on the rear panel of the wireless access point (see Figure 2 on page 12). To restore the factory default settings using the Reset button: 1. Using a sharp object, press and hold the Reset button for about 5 seconds (until the Test LED blinks rapidly) to reset the wireless access point to factory defaults settings. Note: Pressing the Reset button for a shorter period of time simply causes the wireless access point to reboot. [. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Radiation Exposure Statement: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device has been designed to operate with an antenna having a maximum gain of 5. [. . . ]