User manual NEWPOL XD900IXDG

[. . . ] Cleaning the filters in the wash cabinet. Cleaning the drain pump and non-return valve. 33 33 35 36 37 38 38 38 38 39 40 41 41 42 45 58 60 64 4 Guide to the appliance Guide to the appliance Miele dishwashers are available in two versions: 1. Integrated ("i") dishwashers "i"- dishwashers are designed for installation under a continuous countertop. [. . . ] Open the water valve (if closed). If you turn the Program dial past your desired program by mistake: Turn the dishwasher off using the "ON-OFF" button. Turn the program dial clockwise, past the 12 o'clock position, until the start point of the desired program is reached. Turn the machine on. Changing programs Wash temperatures can be changed while a program is running, by pressing the desired button. Turn the Program dial clockwise to the desired program. If a new wash program is desired, use the procedure outlined above. Turning off On completion of a program: The dishwasher will stop at the "End" position. Your Miele dishwasher is designed to shut off the water flow and drain the machine in the rare event of a valve failure. In order for this function to be active, the door must be shut, and the "ON" button must be depressed, even when the machine is idle. Select the desired temperature. (For the "RINSE & HOLD" program, it does not matter which temperature button is pressed). The wash program will begin. 30 Operating the dishwasher Program sequence indication During the wash program, the program knob will move around the dial and show which section of the wash cycle has been reached. - Pre-wash (not shown) - Main wash - Interim rinse - Final rinse - Drying The dial will remain stationary during the heating stages of the wash and rinse cycles, until the required temperatures have been reached. When the program has been completed, the dial will be in the "End" position. Push up on the upper spray arm to engage the tooth-wheel mechanism and then unscrew the spray arm. To remove the middle spray arm located beneath the upper basket, gently push upwards until it engages in the ratchet b, then unscrew it c. To clean the spray arms, use a pointed object to push the the food particles into the jets. Rinse under running water to complete the process. Important: After replacing the spray arms, check that they rotate freely. Lift up on the lower spray arm to remove it. 35 Cleaning and care Cleaning the drain pump and non-return valve. Use caution when cleaning the filters, non-return valve or drain pump, as glass or bone splinters may be caught in the bottom of the wash cabinet. If the water in the dishwasher is not completely drained at the end of a program, the drain pump or non-return valve may be blocked. To clean them: Remove the combination filter. Use a jug or bowl to scoop the water out of the wash cabinet. Rinse the non-return valve under running water. Tilt the locking clamp to the side. The drain pump is situated under the non-return valve (see arrow). Before replacing the non-return valve, check to make sure that nothing is obstructing the drain pump. Spin the impeller several times in both directions; it should turn smoothly. [. . . ] Install the 3/8" compression to 3/4" MHT (Male Hose Thread) adapter (supplied with the machine), as illustrated. Connect the inlet hose to the existing valve/adapter assembly. Electrical wiring and components should not come into contact with any plumbing fixtures or hoses. Do not, under any circumstances, cut the intake hose. If the hose is cut, the dishwasher will not work, you will have a water leak and you could be injured. [. . . ]