User manual NEWPOL XF5 500

[. . . ] 16 Setting the water hardness selector inside the wash cabinet. 30 2 Contents Operating the dishwasher . Cleaning the filters in the wash cabinet. Cleaning the drain pump and non-return valve. [. . . ] For the LIGHT WASH and NORMAL programs, one to two tablespoons of detergent is usually sufficient for excellent wash results. When using "Top Solo" add detergent to compartment II only (approx. 1/2 - 3/4 of the amount used for a full load). 30 Program chart Program cycle Approx. Duration Final rinse Drying Minutes Pre-wash Main wash Interim rinse X X X X 99 X X X X X 106 X X X X X 111 X X X X 75 4) X X X X X 64 4) with half loads (7 place settings) X = cycle used 31 Operating the dishwasher Operating the dishwasher Turning on. Open the door. Press the "I" (ON) touch pad (20). The "ON" indicator lamp will light. Note: When required, the water softener reactivation process is performed before the wash program. During this process the "8 k" indicator lamp will be on. The hardness of the water supply will dictate how often (after how many washes) the water softener needs to be reactivated. For example with a water hardness of 21 gr/gal, reactivation will take place after every 3 programs. With a water hardness of 8 gr/gal, reactivation will only occur after 8 programs. Starting a program. Press the touch pad for the desired program. The indicator lamp for that touch pad will light. If so desired, select "Top Solo" (2) before starting the program. Do not place dishes, bowls or other hollow containers in the bottom basket. Adjusting the upper basket to its lowest position will allow it to accommodate larger plates. Because smaller amounts of dishware are being washed, the amount of detergent used can be reduced accordingly. Using "Top Solo" will also save water and energy. For example, using "Top Solo" with the NORMAL 55 °C/130 °F program uses 3. 2 gallons (12 liters) of water instead of the usual 5 gallons (19 liters). "Top Solo" can be selected with all wash programs. The indicator lamp next to the touch pad will illuminate. Close the door to start the program. 35 Additional features A heating element is used to help dry the dishes in all wash programs. The "Heated drying" feature can be turned off if desired. The dishes will then be dried using the residual heat inside of the machine. For faster drying, the dishwasher door can be opened 2" - 3" at the end of the program to allow the moist air to escape. The 2 and "8 k" indicators will flash. [. . . ] If the water pressure is too high, a pressure reducer must be installed. Existing plumbing: If the standard 3/8" copper plumbing for a dishwasher already exists with a compression fitting and valve as pictured: Do not, under any circumstances, cut the intake hose. If the hose is cut, the dishwasher will not work, you will have a water leak and you could be injured. If the hose is too long, coil it neatly and place it behind the machine. Cut the 3/8" copper tube after the valve. [. . . ]