User manual NEWPOL XF61000EL

[. . . ] 14 Programming and changing the water hardness level. 14 Setting the water hardness selector in the wash cabinet . 29 2 Contents Operating the dishwasher . 41 Cleaning the filters in the wash cabinet . [. . . ] For heavily soiled loads, or if food has dried on the dishes, a program containing a prewash cycle should be selected. Add an extra tablespoon (15 ml) of detergent to compartment I, or place directly on the inner door panel. Dishwasher detergents contain irritant and corrosive ingredients. They can cause burns in the mouth and throat if swallowed, or inhibit breathing. Keep children away from detergent and from the dishwasher when the door is open. To prevent children from coming into contact with dishwasher detergent, do not fill the detergent dispenser until you are ready to start the dishwasher. Capacities: Compartment I (prewash) holds a maximum of 3/4 ounce (20 ml) and Compartment II (main wash) holds a maximum of 2 3/4 ounces (70 ml) when completely filled. The horizontal marks in Compartment II indicate levels of approximately 3/4, 1, and 1 1/4 ounces (20, 25 and 30 ml) respectively. ^ Press the latch on the detergent dispenser. The cover will spring open. ^ Fill the dispenser with 1 ½ tablespoons of powder detergent, or place a detergent tablet into compartment II. 30 Operating the dishwasher Choosing a program Program selection Choose a wash program depending on the type of dishes and the degree of soiling. In most cases the "Light Wash", "Normal" or "Sani Wash" program will give excellent results. Available programs and their applications are listed in the Program Chart. It will come on again for 10 minutes if a button on the control panel is pressed or if the program selector is moved during this delay period. Time display (15) The running time of the program selected appears in the time display (15) in hours and minutes before a program is started. During a program the time left until the end of the program is displayed. The "Time Left" indicator next to the time display lights. The time displayed may vary with the same program. This is because of the water inlet temperature at each intake and because of the amount being washed. When the dishwasher is first turned on the display shows an average time for a cold water intake. Times shown in the program chart refer to normal loads and average temperatures and are for guidance only. 33 Operating the dishwasher At the end of a program A program has finished when no indicator lights are illuminated in the program sequence display (16) and "0" shows in the time display (15). The dishwasher can now be opened and unloaded (see "Unloading the dishwasher"). If the dishwasher is left closed the fan will continue to run for a few more minutes to remove any remaining moisture. This process is not part of the program. Do not open the door immediately after a program has ended unless dishes or cutlery are urgently needed. [. . . ] ^ Refit and secure the combination filter. 54 After sales service After sales service If you are unable to resolve a problem or if the appliance is under warranty, please contact your Miele Dealer or the Miele Technical Service Department. Please have the model and serial number of the appliance available. These can be found on the data plate on the upper inside edge of the dishwasher door. Program update function - PC The "PC" indicator has the function of Program Correction (PC). [. . . ]