User manual NEWPOL XF71007EL

[. . . ] 30 3 Contents Operating the dishwasher . To start a program before the Delay Start period has ended: . Top Solo (for smaller amounts of dishware) . Cleaning the filters in the wash cabinet. [. . . ] Before pressing the "START/Stop" button, select any other desired options (e. g. "Delay start" or "Top Solo". See the "Additional features" section). Press the "START/Stop" button (22). 32 Operating the dishwasher Time display (19) When the "Time left" indicator is on, the display is showing the time remaining in the wash program. When starting a program, the "Time left" can vary, even if the identical program has been run before. The calculated time is partially dependent on the temperature of the intake water. When the dishwasher is turned on for the first time, the time shown assumes an intake temperature of 60 °F (15 °C). For each subsequent program, the actual temperature of the previous programs intake water is used in the "Time left" calculation. Due to this continuous updating, the "Time left" can vary, even for the same program. End of a program When a program is finished, all the sequence indicator lamps (15) will be off, and "0" will be shown in the time display. The program indicator lamp (17) and the lamps for any additional features selected (e. g. Top Solo) will remain lit until the door is opened. Press the "+" or "-" button (20). The delay time used previously will be displayed and the "Delay start" indicator lamp will light. Press the "+" or "-" button (20) to increase or decrease the delay time. Press the "START/Stop" button (18). If the delay time is 10 hours or longer, the display will countdown in 1 hour increments. If less than 10 hours is set, it will count down in minutes. 35 Additional features Example of how delay times are shown: up to 59 minutes: 59 between 1 hour and 9 hours - 30 minutes (example ­ 5 1/2 hours): 5. 3 0 above 10 hours: 15h To start a program before the Delay Start period has ended: Press and hold the "START/Stop" button (22) for at least one second. The indicator lamps next to the Program Selection Buttons and the decimal point in the time display will light. Press the "START/Stop" button (22). The indicator lamp next to the "START/ Stop" button will go out and the program will begin. The program will start automatically when the countdown reaches "0" and the "Delay start" lamp goes out. The "Time left" lamp will light and the display will show the time left in the current program. [. . . ] If the hose is cut, the dishwasher will not work, you will have a water leak and you could be injured. If the hose is too long, coil it neatly and place it behind the machine. Cut the 3/8" copper tubing after the valve. Install the 3/8" compression to 3/4" MHT (Male Hose Thread) adapter (supplied with the machine), as illustrated. Connect the inlet hose to the existing valve/adapter assembly. [. . . ]