User manual NEWPOL XR1760

[. . . ] The manufacturer cannot be held responsible for damages caused by improper use of the hood. This appliance complies with current safety requirements. Improper use of the appliance can lead to personal injury and material damage. READ AND SAVE THESE INSTRUCTIONS This appliance is designed to vent cooking smoke and odors only. [. . . ] ­ to change the number of hours counted by the grease filter timer (see "Operation / Reprogramming the filter timers"). o active charcoal filter button The indicator next to the active charcoal filter button lights when the active charcoal filters need to be cleaned. The button is also used: ­ to reset the active charcoal filter timer after changing the filters (see "Cleaning and Care"). ­ to show how long the active charcoal filters have been in use (see "Operation / Filter timers"). ­ to change the number of hours counted by the active charcoal filter timer (see "Operation / Reprogramming the filter timers"). k On/Off button l Fan power selection m Delayed shut down This button activates the Delayed Shut Down feature. The fan can be set to turn off automatically after either 5 or 15 minutes. 9 Operation Turning on the fan Delayed Shut Down If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. ^ Press the Delayed Shut Down button while the fan is still running: ^ Press the On/Off button. The fan runs at power level "lI". The indicator lights. Selecting the power level Press once = 5 minute delay (left indicator lights) ^ Use the _ buttons to select the desired power level. & = increases the fan speed $ = decreases the fan speed Level "1" to "3" (green indicators) are usually sufficient for normal cooking. Intensive setting Level "4" (yellow indicator) should be used for a short period when frying or cooking food with a strong aroma. Fan performance The maximum air flow capacity is 625 cfm. To help prevent resoiling, a conditioner for stainless steel can be applied. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Cleaning the casing Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. ^ Glass surfaces can be cleaned using glass cleaner. 15 Cleaning and Care Grease filter The reusable metal grease filter removes solid particles from the vented kitchen air (grease, dust, etc). ^ Clean the filters ­ by hand: use a scrub brush in warm water with a mild detergent. ­ in a dishwasher: Place the grease filters vertically in the lower basket, making sure that the spray arm is not blocked. The grease filters should be cleaned every 3 - 4 weeks or whenever the grease filter indicator lights. Depending on the detergent, cleaning the grease filters in a dishwasher may cause permanent discoloration of the filter surface. [. . . ] Verify that the voltage, load and circuit rating information found on the data plate (located behind the grease filters), match the household electrical supply before installing the hood. If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or call Miele's Technical Service Department. USA 1-800-999-1360 CDN 1-800-565-6435 WARNING: THIS APPLIANCE MUST BE GROUNDED Important The hood must be hard wired accordingly: Black/Red wire:. connect to GND (ground) Maximum load . [. . . ]