User manual NEWPOL XS 151EV

[. . . ] The manufacturer cannot be held responsible for damages caused by improper use of the hood. This appliance complies with current safety requirements. Improper use of the appliance can lead to personal injury and material damage. READ AND SAVE THESE INSTRUCTIONS This appliance is designed to vent cooking smoke and odors only. [. . . ] The lighting can be used independently of the fan. k Grease filter button The indicator next to the grease filter button lights when the grease filter needs to be cleaned. This button is also used: ­ to reset the grease filter timer after cleaning the grease filter (see "Cleaning and Care"). ­ to show how long the grease filter has been in use (see "Operation / Grease filter timer"). ­ to change the number of hours counted by the grease filter timer (see "Operation / Reprogramming the grease filter timer"). h On/Off button i Fan power level buttons Four fan speed selection. j Delayed Shut Down This button activates the Delayed Shut Down feature. The fan can be set to turn off automatically after either 5 or 15 minutes. 9 Operation Turning on the fan Automatically switching back the intensive power level The intensive level "4" can be programmed to automatically switch back to level "3" after 10 minutes. The hood turns on on level 2 and the indicator lights. ^ Turn the fan and the lights off. Selecting the power level ^ Press and hold the "Delay Shut down" button for 10 secs. ^ Use the "­/+" controls to select the desired power level. + = increases the fan speed ­ = decreases the fan speed Levels "1" to "3" (green indicators) are usually sufficient for normal cooking. Intensive setting Level "4" (yellow indicator) should be used for a short period when frying or cooking food with a strong aroma. ­ light ^ Press the following buttons one after another, ­ the "­" button, and ­ the light button again. 10 Operation Fan performance The maximum air flow capacity is 625 cfm. The number of flashing "­/+" indicators show the percentage of programmed hours that have been used. powder or cream cleansers, - steel wool or abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents, - limescale removers, - caustic (oven) cleaners. ^ The exterior surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Only use a slightly damp sponge when cleaning the controls. Water could penetrate into the electronics and cause damage. ^ Glass surfaces can be cleaned using glass cleaner. 16 Cleaning and care Grease filter The reusable metal grease filter removes solid particles from the vented kitchen air (grease, dust, etc). Removing the grease filter The grease filter should be cleaned every 3 - 4 weeks or whenever the grease filter indicator lights. Keep the grease filter clean to prevent a fire hazard. ^ To remove the grease filter pull the locking clip forward. Lower the filter 45° unhook it at the rear and take it out. Support the grease filter so that it does not fall onto the cooktop. 17 Cleaning and care Cleaning the grease filter ^ By hand: use a scrub brush with a solution of warm water and mild detergent. [. . . ] Verify that the voltage, load and circuit rating information found on the data plate (located behind the grease filter), match the household electrical supply before installing the hood. If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or call Miele's Technical Service Department. Important The hood must be hard wired accordingly: Black/Red wire:. connect to GND (ground) Maximum load . [. . . ]