User manual NEWPOL XV120EL

[. . . ] 16 After Sales Service Installation instructions 2 IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is intended for residential use only. Use the appliance only for its intended purpose. The manufacturer cannot be held responsible for damages caused by improper use of the hood. This appliance complies with current safety requirements. [. . . ] The fan can be set to turn off automatically after either 5 or 15 minutes. l Grease filter button The indicator next to the grease filter button lights when the grease filters need to be cleaned. This button is also used: ­ to reset the grease filter timer after cleaning the grease filters (see "Cleaning and Care"). ­ to show how long the grease filter has been in use (see "Operation / Grease filter timer"). ­ to change the number of hours counted by the grease filter timer (see "Operation / Reprogramming the grease filter timer"). 9 Operation Main power switch Intensive setting Level "4" (yellow indicator) should be used for a short period when frying or cooking food with a strong aroma. Press the main power switch to "I". The fan and the lighting can now be operated. If the appliance is not going to be used for a long period of time (e. g. while vacationing) turn the appliance off by pressing the main power switch to "0". The next time it is turned on, the hood will operate at the level previously used. Fan performance The maximum air flow capacity is 625 cfm. Factors such as narrow duct diameter and bends will affect this value. ­ A time of 20 hours should be programmed in kitchens with frequent pan or deep frying. ­ A time of 20 hours should also be programmed if the kitchen is only used occasionally. Otherwise grease which has accumulated over a long period of time will harden on the filters making cleaning more difficult. The indicator for the grease filter and one of the _ indicators will flash. The lit _ indicator shows the programmed time: 1st indicator from the left 2nd indicator from the left 3rd indicator from the left 4th indicator from the left = = = = 20 hours 30 hours 40 hours 50 hours. ^ Use the $ or & button to select the desired time. ^ Press the On/Off button to turn off the fan. ^ Store the selection by pressing the grease filter button. If the procedure is not stored within 4 minutes of programming, the hood will automatically default to the "old" data. ^ Press the Delayed Shut Down and grease filter buttons at the same time. 13 Cleaning and care Before cleaning or servicing the hood, disconnect it from the power supply by either removing the fuse, unplugging it from the outlet or manually "tripping" the circuit breaker. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. A dirty filter is a fire hazard. ^ To remove the grease filters press the locking clips in towards the middle of the filter. Holding carefully, lower and remove the filter. 15 Cleaning and care Changing the light bulb Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. To change a bulb: When in use halogen bulbs become extremely hot, and they can burn your hands. Do not attempt to change the bulbs until they have had sufficient time to cool down. [. . . ] Once tight, make sure that the mounting plate can safely support the weight of the hood. ^ Pull the power cord through its cut out on the flange of the chimney. ^ Using at least two people, lift the hood and guide the spring clips through their respective slots in the flange at the top of the chimney. Make sure they click into place and that the hood is hanging securely from the spring clips before allowing them to carry the weight. 28 Installation ^ Bolt the flange firmly to the ceiling using the four M6 nuts. ^ Shorten the power cord as much as possible and attach it to the terminal block inside the chimney (see "Electrical data"). [. . . ]