User manual NEXT BASE SDV77-BD

[. . . ] MO DEL NO. SDV77-BD O P E R AT I N G I N S T R U C T I O N S IMPORTANT SAFETY INSTRUCTIONS ENG Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (Including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] Connect the AC/DC adapter to the power outlet. When recharging starts, the recharge LED lights is red. The recharge LED turns off when recharging completes. Remove the power cord from battery pack. Recharging usually completes in about 3. 5~4. 5 hours. Charge the battery pack fully before using it for the first time. CA UTIO N Place the battery pack and AC/DC adapter on a flat surface for recharging. Do not short-circuit the terminals of the battery pack and AC/DC adapter. Notes: The battery charger(AC/DC adapter) is compatible with supply voltage between 100V and 240V AC and can be used universally. When you want to use it on an overseas travel, be sure to prepare a power plug adapter matching the local power outlet. MOBILE ENTERTAINMENT USING THE BATTERY ENG 24 NOTES FOR RECHARGING When the battery pack is hot, it may take longer time than usual for recharging or may sometimes be unusable to be recharged. Wait for the battery pack to cool down before retrying recharging. If the recharge LED can not be lit, check whether the AC/DC adapter and battery pack are connected firmly to have perfect contact. To protect the battery pack, do not recharge a fully charged battery pack repeatedly. Repeated overcharging may deteriorate the battery performance. The battery pack becomes hot after recharging, but this is not malfunction. The battery pack may not be recharged fully if recharging at a hot place. Do not recharge it under very hot environment, it may cause explosion. The surrounding temperature during recharging affects the recharge efficiency. Recharge is the most efficient between 10 and 30. Recharging the battery pack at a place within this temperature range whenever possible. ATTACHING THE BATTERY PACK TO THE PLAYER Attach the battery pack to the player as described below. 1. Align the fix hole of the player with the fix pole on the battery pack. Turning the batter y knob clockwise until the battery pack is tighten with the player. 3. Now the player can be operated. If the battery pack is fully recharged, the player can play DVDs continuously for over 3 hours. 1 2 MOBILE ENTERTAINMENT 25 ENG USING THE BATTERY If the power is switched on while the battery pack is not fully charged, the player operation may sometimes become unstable. Be sure to charge the battery pack fully before using. [. . . ] Press ENTER to confirm: There are 3 optional audio output modes: SPDIF/OFF, SPDIF / RAW and SPDIF/ PCM. SPDIF/OFF: Choose this setting to output analog signal, and no signal is outputted from coaxial jack. SPDIF/ RAW: Choose this setting if your DVD player is connected to a power amplifier with a coaxial cable. When playing a disc recorded with Dolby Digital, and MPEG audio formats, the corresponding digital signals will be output from the Coaxial Output jack. [. . . ]