User manual NIKON AF-10 SHEET FEEDER (SUPPORTS AX-110, AX-210)

[. . . ] · The information contained in this manual is subject to change · Consult the dealer or an experienced radio/TV technician for without notice. · We have made every effort to produce a perfect manual, but should you find any mistakes, we would be grateful if you would kindly let us know. [. . . ] Turn off your scanner and unplug its power cord from the AC power outlet. Remove the document cover from the scanner. Document cover -3- 3. Fit the two holes in the hinge plate of the AF-10 over the small supporting posts on the scanner. 7. Plug in the scanner's power cord and turn the power switch on. 4. Gently slide the AF-10 so that the supporting posts move into the narrow sections of the holes. Attach the AF-10 with the two lockdown screws provided. Insert screws into the center of each hinge bracket and use a coin to tighten the screws securely. Connect the AF-10 interface cable to the connector on the rear panel of the scanner. Note: When you remove the AF-10, store the two lockdown screws in the holes on the back of the unit, until they are needed again. -4- Using the AF-10 Begin by removing any document from the document setting glass of the scanner, and then make sure that the AF-10 is closed. Place the documents in the upper tray, face up, as shown. 3. Slide the paper guides on the upper tray towards each other, until they just contact the edges of the document stack. The AF-10 can be loaded with up to 50 sheets (a stack thickness of 6 mm or less) of the following paper sizes: Check size A5 B5 A4 Letter Legal 3 x 5 inches 5. 8 x 8. 3 inches 7. 2 x 10. 1 inches 8. 3 x 11. 7 inches 8. 5 x 11 inches 8. 5 x 14 inches (76mm x 127mm) (148. 5mm x 210mm) (182mm x 257mm) (210mm x 297mm) (216mm x 279mm) (216mm x 356mm) 4. After aligning the document stack, insert the documents until you can feel them contact the document-stopper of the AF-10. -5- Loading Documents Manually You can still load documents manually, even with the AF-10 installed. Place the document on the document setting glass of the scanner, then lower the AF-10 and initiate the scan. -6- Troubleshooting Removing a Jammed Document 1. [. . . ] Torn, holed, wrinkled, or folded paper, paper with adhesive tape, carbon, or paper clips attached, or paper with wet ink, can cause a paper jam or damage to the AF-10. 3. 0 to 8. 5 inches (76 to 216mm) 5. 0 to 14 inches (127 to 356mm) 0. 065 to 0. 145 mm 50 to 127 g/mm Paper capacity: 6mm document stack (50 pages for 0. 1t paper) Operating Environment: Temperature: 41°F to 95°F (5°C to 35°C) Humidity: 20 to 85% R. H. [. . . ]