User manual NIKON AF-3-AF-4 GELATINE FILTER HOLDER

[. . . ] When mounted on Nikon DX format cameras, the lens picture angle is equivalent to approximately 1. 5× the focal length in 35mm format. Before using this lens, please read these instructions and refer to your camera's User's Manual. By enabling vibration reduction (VR), slower shutter speeds (approximately three stops*) can be used, thus increasing the range of usable shutter speeds and zoom positions, particularly when hand-holding the camera. [. . . ] Mounting mark on the camera, and rotate the lens counterclockwise until it clicks into place. Be sure that the lens is in the correct position when the mounting index 9 is on the top of the lens. Turn the camera off before removing the lens. Align the lens hood attachment index ( , either of two indexes) 2 on the hood with the lens hood mounting index 4 on the lens, and turn the hood 1 counterclockwise (as viewed when holding the camera With the lens facing away from you) until it clicks into place (Fig. Be sure that the lens hood mounting index is aligned with the lens hood setting index ( ) 3. If the lens hood is not correctly attached, vignetting may occur. Next, while pressing the shutter-release button halfway, manually rotate the lens focus ring 8 to fine-tune focus. Note: Do not attempt to rotate the focus ring while autofocus is operating. If autofocus stops operating, release and press the shutter-release button halfway again. Hold the lens hood by the base (near the lens hood attachment index) and turn clockwise, as viewed when holding the camera with the lens facing away from you, to detach. Before focusing, rotate the zoom ring 5 to adjust the focal length until the desired composition is framed. The built-in flash cannot be used over distances of less than 0. Be careful not to allow the CPU contacts 0 to become dirty or damaged. Clean lens surfaces with a blower brush. To remove dirt and smudges, use a soft, clean cotton cloth or lens tissue moistened with ethanol (alcohol) or lens cleaner. Wipe in a circular motion from the center to the outer edge, taking care not to leave traces or touch other parts of the lens. Never use organic solvent such as thinner or benzene to clean the lens. NC filters are available to protect the front lens element. The lens hood 1 also helps to protect the front of the lens. When storing the lens in its flexible lens pouch, attach both the front and rear lens caps. The lens can also be stored with the lens hood 1 attached in the reverse position. When the lens is mounted on a camera, do not pick up or hold the camera and lens by the lens hood 1. [. . . ] Attachment Ring SX-1 Other accessories may not be suitable for use with this lens. G-type AF-S DX Zoom-NIKKOR lens with built-in CPU and Nikon bayonet mount (specially designed for use with Nikon digital-SLR--Nikon DX format--cameras) 18mm­105mm f/3. 8 oz) Specifications and designs are subject to change without notice or obligation on the part of the manufacturer. E A person standing in front of a distant background In the following situations, autofocus may not perform as expected when shooting with wide- or super wide-angle AF Nikkor lenses. [. . . ]