User manual NIKON AF-S VR 200-400MM F/4G IF ED

[. . . ] Failure to do so could result in a fire, as the lens might focus sunlight onto an object. There may be some restrictions or limitation for available functions. *3 When the Focus operation selection switch is set to AF-ON, autofocus begins as soon as you depress the Focus operation button while lightly depressing the shutter-release button. If this lens is used with cameras not compatible with vibration reduction, set the vibration reduction ON/OFF ring switch to OFF. [. . . ] If the lens mount rubber gasket is damaged, be sure to visit the nearest Nikon authorized dealer or service center for repair. Set your camera's focus mode selector according to this chart: Cameras Camera's focus mode Autofocus with Autofocus with Manual focus AF manual override manual override (Focus assist (C/S) (AF priority) is available. Ring while lightly depressing the shutter release button or the AF start button on the camera or the Focus operation button on the lens. To cancel manual override, remove your finger from the shutter release button or the AF start button on the camera or the Focus operation button on the lens, and lightly depress the shutter release button to return to the autofocus mode. With AF operation, if the subject is more than 8 m (26. This function is only compatible with autofocus. The position of the Focus operation buttons can be changed to suit your preference. For more details on this change, contact your nearest Nikon service center or representative office. Using the Focus lock button (See page 24 for usable cameras. This function is only compatible with autofocus. 3 During autofocus, the focus can be locked while you are pressing the Focus Focus is locked while either of these buttons is pressed. (Otherwise, the lens may emit a chattering noise if the camera is shaken. Turn the camera power ON again to correct this. ) · With F80-Series/N80-Series, F75-Series/N75-Series, F65-Series/N65-Series, D300, D200, D100, D80, D70-Series, D50 and D40-Series cameras, vibration reduction does not work while the built-in flash is recycling. If your camera has a depth of field preview (stopdown) button or lever, depth of field can be observed while looking through the camera viewfinder. Because this lens does not have an aperture ring, you must set the aperture on the camera. When shooting vertical pictures, loosen the tripod collar lock screw by turning it counterclockwise, rotate the lens to an appropriate position, then tighten the screw clockwise. When holding the camera by its handgrip and rotating the camera with the lens in its tripod collar, your hand may bump into the tripod, depending on the tripod in use. The tripod collar can be exchanged for a monopod collar by removing the tripod collar lock screw. After changing the tripod collar, make sure the screw is fully tightened. failure to fully tighten the screw could lead to accidents or damage to the lens and camera. For details on this procedure, contact your nearest Nikon service center or representative office. [. . . ] Never use thinner or benzene to clean the lens as this might damage it, result in a fire, or cause health problems. When the lens is not in use, attach the lens cap to protect the front lens element. When storing the lens in its lens case, attach both front and rear caps. When the lens will not be used for a long time, store it in a cool, dry place to prevent mold. [. . . ]