User manual NIKON AT-10 TRANSPARENCY ADAPTER (SUPPORTS AX-110, AX-210 )

[. . . ] We shall take no responsibility for consequences resulting from the operation of this product, despite the terms mentioned above. When duplicating images with the Unit, the following restrictions must be adhered to: · Reproduction of paper money, coins and government securities is unlawful and such acts shall be punished. [. . . ] The following items are included with your transparency unit. When you open the package, please check whether all items are supplied. If there are any missing items, please contact your dealer immediately. Locate the slider lock on the underside of the unit near the back. Move the plastic slider until the mark points to the Unlocked symbol, as shown below. When transporting or shipping the transparency unit, be sure to re-lock the optical assembly to avoid damage. Before re-locking the assembly, make sure the optical assembly of the unit is in the "Home Position" by doing the following: Turn the scanner's power back on. the optical assembly should be in the Home Position. To lock the optical assembly, move the plastic slider until the mark points to the Locked symbol. Turn your scanner off, and unplug the power cord. Remove the document cover by lifting it up from the scanner to separate the guide posts from their receptacles. Position the hinge brackets of the transparency unit over the supporting posts on the scanner so that the posts fit into the holes in both hinge brackets. Gently slide the transparency unit so that the supporting posts move into the narrow sections of the holes. Insert screws into the center of each hinge bracket and tighten them down. [. . . ] Make sure the transparency fits within the scanning area (see below). u Do not leave transparencies on the glass platten of the scanner for excessive periods of time. [. . . ]