User manual NIKON EH-62D AC ADAPTER

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. 1 Plug the power cable into the AC adapter. 2 Plug the power cable into a power outlet. [. . . ] Connector and insert the power jack into the DC-IN connector (Figure 2-b). Lamp will glow green, indicating that the camera is ready for use. * If you turn off the camera's monitor while using the AC adapter, the green POWER/CHARGE lamp will glow red (if the Nikon EN-EL1 battery is placed in the batter y bay, the lamp will either glow or flash orange). You can continue to use the EH-21 as usual. When operating the camera with the AC adapter, take care that the camera does not accidentally become unplugged. Before disconnecting the AC adapter, be sure the camera is off. Unplug the DC plug from the camera's DC-IN connector, then unplug the power cable from the power source by pulling on the plug, not the cable. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Nikon Corporation may void the user's authority to operate the equipment. Do not apply excessive force to the DC plug or cable while the AC adapter and camera are connected. Failure to observe this precaution may result in malfunction. The AC adapter is on the battery is recharging charging is complete (battery is full) Remove the battery from the EH-21 as described above. The EH-21 AC adapter not inserted/ is supplying power to inserted the camera the ambient temperature is not within the prescribed range Use the EH-21 in an environment with a temperature range within that described in this manual. There is a problem with the battery* Remove the power cable from the power outlet immediately and discontinue charging. When recharging, the ambient temperature should be in the vicinity of 5­35°C (41­95°F). The internal temperature of the battery may rise while the battery is in use. If you attempt to recharge the battery while the internal temperature is elevated, the battery will not charge or will charge only partially. [. . . ] If you attempt to recharge the battery while the internal temperature is elevated, the battery will not charge or will charge only partially. Wait for the battery to cool before charging. If you shake the adapter or touch the battery while the battery is charging, the resulting vibration or static electricity may in very rare instances cause the adapter to indicate that charging is complete although the battery is in fact not yet fully charged. [. . . ]