User manual NIKON MC-20 (OLDER FILM CAMERAS)

[. . . ] Fully depress shutter release button to take the picture. It is possible to perform either single-frame or continuous shooting, depending on the film advance mode set on your camera. [. . . ] When time exposure with electric beeper mode is selected, a short beeping sound will repeat each second for the duration of the exposure. To close the shutter and stop the exposure, fully depress the shutter release button again. To reset display to ?0 00 00?, depress the shutter release button again. Shooting in a dark place In dark situations, when the LCD panel is difficult to see, press the LCD illumination button. The LCD panel will remain illuminated for as long as the LCD illumination button is depressed. cord Kabel ??? MODE button MODE-Taste ???????????(H)??(M)??(S) Time adjust buttons: H (hour) , M (minute) and S (second) Zeit-Einstelltasten: H (Stunde) , M , (Minuten) und S (Sekunden) ?????? Plug Stecker Battery chamber lid Batteriefachdecke ????? LCD panel LCD-Feld ?????????? LCD illumination button LCD-Beleuchtungstaste ?????? Lock screw Feststellring ???????? Shutter release button Auslser Installing Battery (battery not required when connected to F5, F100, F90X/N90s, F90-Series/N90, D2H or D1-Seires camera body, or MB-D100 attached to the D100) (Figure 1) Slide open battery chamber lid. When battery is exhausted, the display becomes dim; replace battery with new one. With battery installed, Remote Cord MC-20 can be used with an F5, F100, F90X/N90s, F90-Series/N90, D2H, D1-Series or MB-D100 attached to the D100, but power will be supplied from the installed battery, not from the camera body/Battery Pack. With the shutter speed set to a position other than B or BuLb, shutter is released and film (if loaded) is wasted when MC-20?s shutter release button is pressed. To avoid this, be sure to set the shutter speed to B or BuLb. When using the Photo Secretary software with a Nikon F5, F100, F90X/N90s or F90-Series/N90 camera, you can use ?Time?However, for Long-Time Exposure with the MC-20, do not use ?Time. Press MC-20?s MODE button to select long-time exposure mode, or press again to select long-time exposure mode with electric beeper. [. . . ] To connect to a camera or Motor Drive other than F5, F100, F90X/N90s, F90-Series/N90, D2H, D1-Series or MB-D100 attached to the D100, align groove in the MC-26 (optional) plug with the notch inside the remote terminal of the motor drive or camera, then insert plug and screw the lock ring onto the plug. Specifications Suitable camera: Nikon F5, F100, F90X/N90s, F90Series/N90, D2H, D1-Series or D100 with the MB-D100 Other cameras with remote terminal: Nikon F70Series/N70, F4-Series (other than F4), F-801/N8008, F801s/N8008s, F-501/N2020 or F-301/N2000 camera, or Motor Drive MD-4 attached to an F3-Series camera or MD-12 attached an FM2 camera can also be connected using Adapter Cord MC-26 and lithium battery CR2032 Attachment method: Lock screw Timer display: 7-segments per digit, 5 digits Mode display: LONG EXP, TIME and - - - - - (normal mode) Electric beeper: Emits sound during long-time exposure or time mode LCD illumination: LCD illumination button Battery duration: Approx. [. . . ]