User manual NILFISK 3151T

[. . . ] Keep the manual near the machine, in a protected and dry place away from direct sunlight and ready to hand for future consultation when required. Ask for another copy from your Dealer or the manufacturer if this manual is lost or deteriorates. Inform the manufacturer about the name and address of the new owner if the machine is sold to third parties. This manual reflects the state-of-the-art at the moment the machine was sold and cannot be considered inadequate if modifications are subsequently made in compliance with further experience. [. . . ] Failing this, the manoeuvre would have no effect while the filter itself could be damaged. B - Panel power plate Data plate code: 817089 Indicates that the panel is powered by the voltage given on the data plate. For this reason, only explicitly authorized persons may be allowed access to the electric panel and only after having disconnected the machine from the electricity source by removing the plug from the socket. Check that all guards are correctly positioned and fully efficient before starting and using the machine. Always check that the protections and safety devices are mounted and efficient at the beginning of each work shift or before using the machine. If this is not the case, switch off the vacuum and inform the person in charge. Each component has been selected in compliance with the safety guarantees supplied by CFM. Each structural element is connected to the ground cable in order to eliminate all risks of the operator being electrocuted even in the case of an electrical fault. All electrically powered components and all moving parts are protected by casings or guards able to prevent even accidental contact with the operator. The vacuum cleaner is covered by a box (fig. On arrival, check the machine to see that it has not been damaged during transport. Turn off the vacuum cleaner by removing the plug from the power socket (mod. On models 3051T - 3101T - 3151TTT, set the main switch "3" (if installed as an optional) to position "0" (off) and then remove the plug from the power socket. - It is also advisable to clean the primary filter by using the relative knob as described in paragraph 6. - Wait a few minutes for the dust to detach from the filter and deposit in container "7" (fig. - Release the two closing clips "4" and remove the cover "5" along with the primary filter (fig. - Release the two closing clips "6" and remove the waste container "7", holding it with both the handles "9". - To remount the container "7", fit it back in place so that the two clips "6" fit into the relative fins. Now lock the two clips "6" in place and remount the cover "5" along with the filter, complying with the demounting instructions in reverse. Turn off the vacuum cleaner by removing the plug from the power socket (mod. On models 040/22T-100/28T-150/36, set the main switch "3" (if installed as an optional) to position "0" (off) and then remove the plug from the power socket. - It is also advisable to clean the primary filter by using the relative knob as described in paragraph 6. [. . . ] Proceed in the following way to replace electric power cable "1". 3051 - 3101 - 3151TT - Open the electric box "2" and slacken off core hitches "3" and "4". 3151TTT - 3101T - 3151TTT - Open control box "5" and slacken off core hitch "6". Disconnect the three mains wires and the "yellow-green" ground wire from the terminal strip. [. . . ]