User manual NILFISK A15 DXX

[. . . ] A = Vacuum model B = Serial number C = Category D = Weight of the machine E = Year of manufacture F = Machine built in compliance with Machine Directive 89/392/EEC A = Saugermodell B = Seriennummer C = Zugehörigkeitsgruppe D = Maschinengewicht E = Baujahr F = Maschine in Konformität zur Maschinenrichtlinie 89/362/EWG gebaut 3 - Symbols used in this manual Comply with the safety indications and prescriptions in this instruction manual. This symbol is used to call your attention to dangerous operations or machine parts as could cause personal injuries or even the death of the operator, or as could cause even irreparable damage to the machine. This manual depict the machine or machine parts with their panels or casings removed. Never ever use the machine The machine was delivered to the user according to the conditions that were valid at the time of purchase. [. . . ] Before using the vacuum cleaner, operators must be informed, instructed and trained on how to work it and for which substances its usage is permitted including the safe method for removing and disposing of the vacuumed material. And technical assistance procedures and information given in this manual. Never ever use gasoline, solvents or other inflammable liquids such as detergents. Never open the waste container Do not move the vacuum cleaner by pulling the feed tube since this could damage or impair the tightness of the air connection. Machine operators must be persons working in the sector who have been specially trained for the purpose and who have read and understood the instructions described in this manual. The employer shall inform the personnel about risks of accidents, the devices and garments required for the safety of the operator, risks from excessive noise levels and about the general provisions established by the European Directives and legislation of the country where the machine is installed. The term "operator" means the person that carries out the following tasks: - accomplishment of operations required in order to run the machine. Information The tasks carried out by the relative personnel are not rigidly defined since the operator may possess know-how enabling him to carry out more than one job. - Manufacturer's technician: carries out installation, setting up and modification work in accordance with the manufacturer. On arrival, check the machine to see that it has not been damaged during transport. If this is the case, immediately lodge a complaint with the haulage contractor. If the Customer stores the machine before it is used, it must be kept in a sheltered place protected against strong temperature variations. The machine should also be prevented from overturning as this could create accidents. The customer should provide the following at his charge: - an air supply line with condensation free air; - an air filter with on-off cock equipped with a quick coupling between the air main and the connection tube of the vacuum cleaner. If seal between the head and the filter chamber fails to guarantee tightness: - unscrew screws "A" that lock fastening latches "B" in place and allow them to slide downwards until lid "C" closes perfectly. If seal between the container and filter chamber fails to guarantee tightness: - loosen the screws "A" that lock filter chamber "B" against vacuum structure; - allow filter chamber "B" to lower down and relock screws "A" once it has reached the retention position. Before using, make sure the aspirator is suitable for the environment and for the job to be done (see machine identification plate para. - Open and close the air flow by means of tap "B". Keep long suction pipes as straight as possible. Do not allow them to become bent or twisted as this will cause easy wear and clogging. Information Periodically check the quantity of vacuumed product in the waste container since this could clog the primary filter if excessive. A15 DAXX ("ATEX") versions, the machine must be connected to an earth point by means of pincers "A". [. . . ] The filter must be replaced with one of identical characteristics, filter surface and category. Failing this, the vacuum cleaner will not operate correctly. Insert one hand inside in order to reach split pin "D". - Lift filter "C", cut the clamps "G" and detach the ring "F" from the filter. [. . . ]