User manual NILFISK B23 STAINLESS

[. . . ] The waste water drains into the wash tray underneath the parts being cleaned. The wash tray can be adjusted to any height between 460 and 1190 mm (top of wash tray). Capacity Temperature, adjustable Heating time from 15 to 85°C Electric cable with plug, length Pressure hose, length Dimensions: · 1 General Upon the unpacking of your Nilfisk-ALTO B23 brake washer you should check it for any defects. If you find any, we kindly ask you to contact your nearest Nilfisk-ALTO distributor. [. . . ] Cable connections should be kept dry and off the ground. Never direct the water jet towards people, pets, electric wiring, or the machine itself. Never open the pressure tank or detach the hose when the system is under pressure. Do not tamper with the air valve or the safety valve. Only use original Nilfisk-ALTO spare parts for repair and maintenance. Only Nilfisk-ALTO spare parts ensure that your washer is operational and reliable. Do not use the machine if the safety devices, electrical connections or the pressure tank are defective. Persons under the influence of alcohol, drugs and medicine should not operate the machine. When using detergents the enclosed instructions should always be strictly observed. Always unplug before you perform any cleaning or maintenance of the machine. Place the wash tray and the wash basket and secure the adjusting handle to the correct height. Attach the spray handle with the hose by screwing the hose onto the outlet at the top of the washer. open the detergent tank by unscrewing the cap. Fill the tank with an adequate mixture of water and detergent until the liquid is visible from above (max. Screw on the cap and tighten it by hand - do not use a tool or overtighten. Start the washer with the switch (12) that is lit green, and set the temperature dial (11) to the required temperature. When the required temperature has been reached, the red indicator will go out and the thermostat will ensure that the temperature is kept constant. Disconnect the plug from the socket and wind the cable round the transport handle. The pressure in the tank is increased with ordinary compressed air through the compressed-air valve at the top of the screw cap. Use only compressed air and no other pressure medium. [. . . ] 1 General Only use detergents with the following pH value: B23 Stainless : pH 4 - 13 Unsuitable detergents may damage the washer as well as the item which is being cleaned. For B23 Stainless with a stainless steel tank we recommend you to use Nilfisk-ALTO Allosil® which is an alkaline detergent. 2 Allosil® Special product for water based degreasing and cleaning with hot or cold water. 1 Guarantee Our general conditions of business are applicable with regard to the guarantee. [. . . ]