User manual NILFISK C 105.5

[. . . ] Hold the spray lance firmly with both hands. The spray lance is affected by a thrust of up to 16. 4 N during ope­ ration. The operator and anyone in the immediate vicinity of the site of cleaning should take action to protect themselves from being struck by debris dislodged during operation. Wear goggles and protection clothes during operation. [. . . ] Place the trolley handle on the machine. Secure the handle by mounting the 2 screws. Use the enclosed hexagon key. 3. 2 Mounting of quick coupling 1. Screw the quick coupling tight on to the water inlet (2). Note: The inlet filter (2a) must always be fitted in the water inlet pipe to filter out sand, limestone and other impurities as these will damage the pump valves. Caution: Failure to fit the filter will invalidate the guarantee. 3. 3 Mounting of high pressure hose on spray handle 1. Attach the high pressure hose (4) to the spray handle (7). Detach the high pressure hose by pressing the pawl (A). A 6 Nilfisk C 105. 5 / C 115. 3 4 Operating your pressure washer 4. 1 Connection of high pressure hose 1. Mount the high pressure hose on the outlet (3). EN 4. 2 Mounting of spray lance and Click & Clean nozzles 1. Push the spray lance (6) into the spray handle (7) and screw it on. Note: The spray lance (6) has a built-in low pressure nozzle that can be used for flushing away dirt. 2. Warning: When attaching the Click & Clean nozzles, the pawl on the side of the spray lance (6) should come out again. Note: The foam sprayer (11) features a swivel lock, which must be positioned in the hole in the Click & Clean spray lance (6). Press the pawl to detach the Click & Clean nozzle. 7 Nilfisk C 105. 5 / C 115. 3 EN 4. 3 Water connection An ordinary 1/2" garden hose of min. NOTE: Connection to the public mains according to regulations. IMPORTANT!If there is a risk of running sands in the inlet water (i. e. from your own well), an additional filter (106411231) should be mounted. Let the water run through the water hose before connecting it to the machine to prevent sand and dirt from penetrating the machine. Note: Check that the filter is fitted in the water inlet pipe and that it is not clogged up. Connect the water hose to the water supply by means of the quick connector (inlet water, max. Turn on the water. 4. 4 Start and stop of the machine The spray lance is affected by a thrust during operation - therefore always hold it firmly with both hands. IMPORTANT: Point the nozzle at the ground. Check that the machine is in uprigth position. NOTE: Do not place the machine in high grass! [. . . ] that the high pressure washer has not been used for rental nor used commercially in any other way. Repairs under this guarantee include replacement of defective parts, exclusive of packing and postage/carriage. Besides, we refer to your national law of sale. The machine should be forwarded to one of the service centres of the Nilfisk organisation with description/specification of the fault. [. . . ]