User manual NILFISK CR 1000 XL

[. . . ] This manual will help you get the most from your Nilfisk-Advance Sweeper / Scrubber. Read it thoroughly before operating the machine. References to "right" and "left" in this manual mean right or left as seen from the driver's seat. Repairs, when required, should be performed by your Authorized Nilfisk-Advance Service Center, who employs factory trained service personnel, and maintains an inventory of Nilfisk-Advance original replacement parts and accessories. [. . . ] This mixture is then fed to the floor where two or three disc scrubbing brushes (B) work to dislodge soil. After scrubbing, the dirty solution is vacuumed from the floor by the squeegee (C) and discharged into the recovery tank (D). At intervals, a float switch activates the recycling pump (E), which sends filtered solution from the recovery tank to the solution tank. When the machine is in motion, do not push the directional/speed control pedal all the way forward. This is the same as starting in "high" and will put a strain on the motor and drive system. plan your sweeping and scrubbing in advance. Try to arrange long runs with minimum stopping and starting. Sweep debris from narrow aisles (A) out into main aisle (B) ahead of time. do an entire floor , or section at on time. Pick up oversize debris before sweeping. Allow a few inches of overlap of sweep and scrub paths. This will eliminate leaving dirty patches. Don't turn steering wheel to sharply when machine is in motion. The machine is very responsive to movement of the steering wheel; so avoid sudden turns. When placing the machine in motion, avoid slamming the drive pedal all the way forward suddenly. This is equivalent to starting out in "HIGH" and puts needless strain on the drive system. Periodically, turn the sweeping broom end for end to prevent the bristles from "settling" in one direction. TO STOP THE CLEANING OPERATION Discontinue the cleaning operation when the low solution light or the high recovery light illuminates, this indicates the solution tank is empty or recovery tank is full. Discontinue the scrubbing cycle, put all controls in the forward position for transport and drive to the drain area. To drain the tank, remove and lower the hose and place in a suitable floor drain as shown in figure 42. open the drain hose plug as shown in figure 43 and 44. When replacing the drain hose make sure the clip (A) on the drain hose plug is facing out as shown in Fig. [. . . ] Fill the reservoir until the fluid is at the "FULL" line on the hydraulic fluid sight gauge (B). The sight gauge is located on the center side of the hydraulic reservoir. Put a container under the reservoir drain to catch the reservoir fluid. Put the reservoir plug, removed in step six, back in the hydraulic tank drain and tighten it. [. . . ]