Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual NILFISK E-VAC2000. We hope that this NILFISK E-VAC2000 user guide will be useful to you.
Lastmanuals help download the user guide NILFISK E-VAC2000.
Detailed instructions for use are in the User's Guide.
[. . . ] The main broom stop (JJ) must be re-adjusted when the broom is replaced. NOTE: The machine should be stored with the Main Broom in the raised position. The engine must not be running when performing this procedure. [. . . ] pivot the idler arm assembly out of the main broom core. Pull the main broom out of the broom housing and remove any string or wire wrapped around it. Also inspect the skirts at the front, back and sides of the broom housing. The skirts should be replaced or adjusted if they are torn or worn to a height of more than 1/4 inch (6. Turn the broom around (end-for-end) and slide it back into the B1 broom housing. Drive the machine to an area with a level floor and set the parking brake (GG). Remove the Right Engine Access Panel (37) and look at the Pull the Main Broom Raise / Lower (ON/OFF) Lever (II) back and slide to the right and up to lower the main gauge on the side of the reservoir. If the oil level is below the minimum level, add 10W30 motor broom. Push lightly on the front of the Drive Pedal (OO) to start the main broom rotating. This valve prevents damage to the hydraulic system when the machine is being towed/pushed short distances without use of the engine. Turn the valve 90 degrees; this disengages the hydrostatic lock between the motor and pump. The hydrostatic pump can be damaged if the machine is towed with the valve in the normal working position (A3). Reference the illustration below for the normal working setting (A3) and the free wheeling towing setting (B3). Note: If the tow valve is left in free wheeling (B3) position the hydrostatic pump can't drive the machine FWD or REV. no damage will result , just re-set valve to the normal working setting (A3). Tow or push machine no faster than a normal walking pace (2-3 miles per hour) and for short distances only. If the machine is to be moved long distances the rear drive wheel needs to be raised off the floor and placed on a suitable transport dolly. Do not remove the radiator cap when the engine is hot. [. . . ] The side broom(s) are adjusted simply by pressing and holding the Side Broom DOWN/ON Switch (N) or the Steering Rack Side Broom UP/OFF Switch (Y) until the desired amount of bristles are contacting the floor. Once every 150 hours pump a small amount of grease onto the steering rack and pinion NOTE: The machine should be stored with the Side Broom(s) in the raised position. the Side Broom(s) should be replaced components. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE NILFISK E-VAC2000
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual NILFISK E-VAC2000 will begin.
