User manual NILFISK FLOORTEC 550 B

[. . . ] La balayeuse est conçue et fabriquée pour le nettoyage (balayage) de planchers lisses et solides, en milieux civils et industriels, et pour le collectage de poussieres et déchets légers, en condition de complete sécurité, par un Opérateur qualifié. ­ Electronic battery charger manual (if equipped), which is to be considered an integral part of this manual. Moreover, the following manuals are available: · Spare parts list (supplied with the machine). The purpose of this Manual is to provide the operator with all necessary information to use the machine properly in a safe and autonomous way. [. . . ] B) Lead battery installed on the machine but dry, that is without liquid electrolyte. Be extremely careful when working with sulphuric acid, as it is corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and call a physician. Fill up each battery element with sulphuric acid for batteries (density from 1. Let the battery rest and fill in with sulphuric acid in accordance with the instructions specified in the Battery manual. Proceed with machine and battery charger (if installed) setting according to the chosen battery type. The machine setting performed at the factory is for lead (WET) batteries. If this setting corresponds to the type of battery installed on your machine, go to the next paragraph, otherwise perform the following operations: 4. B) and take out the control panel (1) with care. B) in the control panel; turn it to "I" position [without pulling the lever (4)], then check that the green warning light (5, Fig. If the warning light becomes green or red (3 or 4, Fig. B) take the ignition key to "0" position and take it out. B) by means of the handles (5), to reach a comfortable position. C), disengage the handle (12) from its retainer (2) and lower the handle (without turning it). C) can be lowered also when it is running. Check that the green warning light (5, Fig. If the warning light becomes green or red (3 or 4, Fig. B) take the ignition key to "0" position, then charge the battery. C) with care until the machine starts to move. The speed is proportional to the pressure applied to the selector lever (4, Fig. Avoid stopping for a long time with the machine in the same position and the brooms rotating: this could create unwanted marks on the floor. For the machine to sweep properly the dust filter must be as clean as possible. [. . . ] N) larger than 20 mm or cracks (2) larger than 10 mm (for skirt replacement, refer to the Service Manual). Q) rub lightly on the floor but are not completely lifted from the ground (see figure P). If necessary, adjust the skirt height using its slots (3, Fig. Do not smoke while charging the batteries. [. . . ]