User manual NILFISK FLOORTEC 560 P

[. . . ] www. nilfisk-alto. com FLOORTEC 560 P DEUTSCH FRANÇAIS ENGLISH NEDERLANDS BETRIEBSANLEITUNG MANUEL D'UTILISATION USER MANUAL GEBRUIKSAANWIJZING B 3 2 3 3 D E 1 S310027 S310028 3 S310072 F G C 2 17 5 24 8 18 19 22 27 26 29 2 31 S310029 S310030 1 3 H I 16 6 11 10 15 23 13 5 2 4 9 30 28 6 12 20 S310074 S310032 J K 8 25 7 14 21 S310088 S310075 S310034 USER MANUAL ENGLISH INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 MANUAL PURPOSE AND CONTENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 TARGET . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 HOW TO KEEP THIS MANUAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] T). 6 FLOORTEC 560 P 146 2592 000(1)2005-03 A USER MANUAL 7. After about 5 seconds the engine runs, disengage the air lever (starter) (1, Fig. C) but introducing the hand in the compartment (29, Fig. C), disengage the handle (10) from its retainer (11) and lower the handle (without turning it). C) can be lowered and lifted also when the engine is running. C) with care until the machine starts to move. The speed is proportional to the pressure applied to the selector lever (3, Fig. 9. NOTE When the dust filter is obstructed and/or the hopper is full, the machine cannot collect dust and debris anymore. To avoid damaging the dust filter do not work on wet grounds. C) should be emptied after each working period and whenever is full. NOTE When the hopper is full the machine cannot collect dust and debris anymore. The petrol engine has a warning system to prevent damages to the engine provoked by an insufficient quantity of oil in the carter. Before the carter oil level goes below the safety limit, the oil warning system automatically stops the engine. Stopping the machine 1. C) (without turning it) and engage its retainer (11). C) rotation and the suction valve (24, Fig. U) operation, turn the on/off key switch (2, Fig. C). EMPTYING THE HOPPER Release the selector lever (3, Fig. Activate the filter-shaker by means of the handle (19, Fig. C) pull out the hopper (16) and empty it in the specific container. Take back the hopper to its normal position and engage the hook (17). The machine is ready to start working again. Avoid stopping for a long time with the machine in the same position and the brooms rotating: this could create unwanted marks on the floor. [. . . ] ­ Reassemble in the reverse order of disassembly. Right skirt: ­ Remove the main broom, as described in the related paragraph. U) from the pulley (21); to facilitate the operation, make the pulley (21) rotate operating on the fan (24). C) and the right cover (23) together with the belt (17, Fig. [. . . ]