User manual NILFISK GM 55 TEMPEST

[. . . ] Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit. Avoid picking up hard, sharp object with the vacuum cleaner as they may damage the cleaner parts. Do not block the suction or the exhaustion part. [. . . ] When you check bag status by indicator, set motor power on maximum position. REPLACING THE DUST BAG NOTE : Hose must be disconnected before changing bag. Replace the dust bag as soon as it is full. To open the dust cover of the dust bag compartment, lift the front of cover upwards. Insert the cardboard bag collar of the dust bag as far as it can go on the suction inlet along the slide guide. Position the dust bag so that no part of the bag is pinched. Press the front of dust cover down lightly until it re-locks. NOTE : In the absence of a dust bag, the cover cannot be closed, do not close forcibly. 5 GM 55 IF YOU USE PAPER DUST BAG After using, if the paper dust bag is full of dust, dispose the paper bag. IF YOU USE CLOTH FILTER BAG After using, if the cloth filter bag is full of dust, clean the cloth filter bag and use it again. After washing, it should be dried thoroughly. Serious injury may result. NOTE: There are two types of dust bag according to the model. One is paper dust bag type, the other is a cloth filter bag type. CORD STORAGE To extend the power cord for use, grasp the plug and gently pull out from the vacuum cleaner. When removing the power cord from the electrical outlet, switch off the power and grasp the plug. Your cleaner is equipped with an automatic rewind button. After cleaning, switch off power and disconnect the plug from the electrical outlet then press on the cord rewind button. The cord will be rewound automatically. ON / OFF BUTTON With the cord plugged into an electrical outlet, start or stop the vacuum cleaner by pushing lightly on the switch downwards. PARK POSITION Located on the top rear side of the vacuum cleaner, there is a support for a convenient park position during pauses when using the nozzle. STANDS ON END Your cleaner is designed to stand firmly upright for cleaning or storage. Use in this manner and it takes up minimum space, and allows you to work in the narrowest spaces. 6 GM 55 USING THE ACCESSORIES CREVICE DUSTING Crevice tool radiators, crevices, corners, between cushions. Dusting brush for furniture, shelves, books, etc. · Before use, assemble the dusting brush to the crevice tool TOOL STORAGE Your cleaner features an tool storage device. Assemble the accessory hanger on to the extension tube. It can be used to store the cleaning tool while they are not in use. This tool can be separated into two parts. CARE OF FILTERS SECONDARY FILTER To protect the motor, your cleaner features a secondary filter at the front of the motor in the dust compartment. Do not allow the filter to become clogged. Suction power reduction or motor damage may result. After cleaning the secondary filter attach it in place. SECONDARY FILTER SECONDARY FILTER OUTLET FILTER 1) Separate the exhaust filter. 2) Reassemble it after cleaning or replacing the filter in the reverse order. NOTE: The filters must be completely dried before being replaced in the dust compartment. 7 GM 55 CYCLONIC FILTER(ONLY CYCLONIC FILTER TYPES) You can use a dust bag in your cleaner for a long time thanks to the Cyclonic Filter system and it maintain the maximum cleaning efficiency. The larger particle of dust filtered from Cyclonic Filter remain in Dust Barrel when suctioned air and dust revolves in the Cyclonic Filter. [. . . ] Nor will it cover incorrect, poor configuration, ie. Setting up or connection, nor fire damage, fire, lightening strike or unusual voltage fluctuations or any other electrical disturbances such as defective fuses or defective electrical installations on the supply grid, and defects or damage in general that NilfiskAdvance consider to be the result of causes other than manufacturing and material defects. THE GUARANTEE BECOMES VOID: If a defect is caused by the use of non original Nilfisk dust bags and filters, if the identity number is removed from the vacuum cleaner. If the vacuum cleaner has been repaired by a non-Nilfisk authorised dealer. [. . . ]