User manual NILFISK GM 80 CLASSIC & GM 80 VACUUM,MV

[. . . ] Maskiner som er laget for tørrsuging må ikke brukes for oppsuging av vann eller andre væsker. 2 Demontering av bøyde rør Det kan være behov for å ta av det bøyde røret for å fjerne en eventuell blokkering. Att sätta tillbaka motorn - 80 När du sätter tillbaka motorn, se till att omkopplaren är rakt över insuget till behållaren och att kontakten är riktad bakåt. 13 ENGLISH (Only for grounded appliances): GROUNDING INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE This appliance must be grounded. [. . . ] No changes or modifications to the mechanical or electrical safety devices should be made. 1 Starting / stopping 1 Place the appliance plug of the cable in the motor socket. After cleaning, unplug the cable from the wall socket. Detaching the power cord To prolong the life of your cord, detach it from the motor each time after cleaning, roll it up loosely and store it. 2 Note Do not roll the cord tightly around the motor as this will place a strain on the cord and considerably shorten its life. thermal cut-out protection (Only USA and Canada) The vacuum is provided with a thermal cut-out protection mechanism. This prevents the motor from overheating if a blockage should occur. If this occur start by removing the electrical cord from the power outlet. Then remove the cause of the blockage to allow free air passage. Then put back the electrical cord to the power outlet. when the motor is cool , it will automatically start again. 3 Micro-Static Filter The grey Micro-Static filter on the top of the motor attracts and retains micro-particles efficiently. In order to ensure a constant cleaning of the exhaust air and to avoid overheating of the motor, it is essential that the filter is replaced regularly. The Micro-Static filter should be replaced after approx. 50 hours use, equivalent to one year of domestic use. Replacing 1Turn the two screws with a coin until their slots are vertical. 2 Release the handle by a gentle downward pressure at its centre. Press until both ends spring out from the motor recess. 3 Lift off the exhaust grill and the filter. The sound absorbent material must remain on top of the motor. 4 Remove the grey filter and mount the new one. Locate the handle into position and lock it by turning the screws until their slots are horizontal. [. . . ] Turn the motor clockwise until a distinct click is heard. If the motor will not lock into position by turning, then press the red locking lever inside the container in the direction of the arrow. 16 8 Suction with dust bag The cleaner is supplied with a two-ply self-locating dust bags. To release the container, unfasten the two latches and lift off the upper part with the motor/filter section. [. . . ]