User manual NILFISK GM 82BP

[. . . ] In all cases freight both ways will be at the expense of the customer. Equipment shall not be returned without advance notice to, and consent of the Nilfisk companies. 2 EXCEPT AS SPECIFICALLY SET FORTH HEREIN, THE NILFISK COMPANIES MAKE NO WARRANTIES, EITHER EXPRESSED OR IMPLIED AS TO ANY MATTER WHATSOEVER, INCLUDING WITHOUT LIMITATION ANY AND ALL WARRANTIES OF MERCHANTABILITY, FITNESS FOR PURPOSE, OR OTHER WARRANTIES, ALL OF WHICH ARE EXPRESSLY DISCLAIMED AND EXCLUDED. NEITHER PARTY SHALL BE LIABLE TO THE OTHER FOR SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LOSS OF PRODUCTION, LOSS OF TIME, LOSS OF PROFITS OR OTHER SIMILAR INDIRECT LOSSES WHICH MIGHT OCCUR AS A RESULT OF DEFECTS, PARTIAL OR TOTAL FAILURE OF THE PRODUCT TO PERFORM AS SPECIFIED. Correction of non-conformities or defects in the manner and for the period of time provided above, shall constitute fulfillment of all liabilities of the Nilfisk companies to the customer, whether based on contract, negligence or otherwise with respect to, or arising out of such equipment. [. . . ] Fasten the motor head in place using either the positive twist safety latches or the standard latches, depending on which option you purchased. Installing the Polyliner and Paper Bag: Twist and release the two positive twist safety latches, or the standard latches, depending on your machine. They are located on the body of the container, front and back. Open the polyliner and place in the bottom of the container with its walls flush against the container sides and lipped under the container inlet (photo 3). The excess length of polyliner is draped over the top of the container and down the outside then rolled at the end to permit the container clips to close. Install a paper bag inside the polyliner according to the illustrations printed on the paper bag itself (photo 4). Replace the top container and fasten the two clips. If you choose not to use a polyliner, follow the instructions to install the paper bag. Photo 4 4. The GM 810 and GM 82BP offer a wide variety of hoses and accessories. Consult your local District Sales Managers or Customer Service Department at (800)-NILFISK for a list of optional hoses and accessories. No matter what hose option you have chosen, it can be connected in the following manner. Carefully remove and discard with collected debris in the sealable poly bag. If 5 equipped with a Gore-Tex microfilter, the same rules for periodic inspection and disposal apply. The Gore-Tex microfilter has a clamp that holds it in place. The GoreTex filter must be changed when any abrasions, damage or heavy discoloration is noticed on the surface of the filter (refer to photo 1). Photo 8 3. HEPA or ULPA Exhaust Filter: This cartridge is mounted on the top of the motor, outside the container. If the main filter and microfilter are properly maintained, the glass fiber element in the exhaust filter should perform satisfactorily for a minimum of one year. Exact life will depend upon frequency of use and amount and type of material collected. Normally four changes of microfilter equal one change of HEPA/ULPA filters. Remove the protective metal casing and replace the pleated glass fiber cartridge according to the accompanying instructions (photo 8). Cartridges must be replaced more frequently if the cleaner has had unusually heavy use, or if the various pre-filters have been neglected. CAUTION: Use only genuine Nilfisk replacement filter components. The use of substitute components could pose a grave risk of personal exposure, and will cause all equipment warranties to be void. [. . . ] 1) Check the condition of the main filter and microfilter (refer to photos) and determine whether there is an excessive loading of debris. If there is overloading in the main filter, you can shake it out. If the microfilter is loaded, or there is any other problem with the microfilter, it needs to be replaced. Call our Customer Service Department at (800) 645-3475, extension 2 to order replacement filters. [. . . ]