User manual NILFISK GU 455-DUAL

[. . . ] This manual will help you get the most from your vacuum cleaner. Read it thoroughly before operating the machine. Repairs, when required, should be performed by your Authorized Service Center, who employs factory trained service personnel, and maintains an inventory of original replacement parts and accessories. Please specify the Model and Serial Number when discussing your machine. [. . . ] Push the Handle (1) into the opening at the top of the Dust compartment until the button at the rod snaps in place and secure the handle to the housing. Never operate the vacuum cleaner without a Dust Bag in place. These machines are equipped with an "no bag" clip. This means that if a dust bag not is fitted or fitted uncorrectly - the dust lid (5) would not be able to close. Foot pedal must be used to release base to operating/non operation position. Failure to do so could result in damage to the release mechanism. Insert the handle at the opening at the top of the bag housing, until the button at handle snaps in place. Release the power cord from the cord hooks (2) at the backside of the vacuum cleaner. Turn the lower hook so that the cord is released. Adjust the height of the handle, by pushing at the handle lock button (4) and then pull or push at handle to comfortable height. Add the cord to the hook of the handle in order to make an anti strain function. Then plug-in the power cord into a electrical outlet. Step on the Pedal (11) and then tilt the cleaner backwards. On single-motor versions, the brush is always turning when on. Foot pedal must be used to release base to operating/non operation position. Failure to do so could result in damage to the handle release mechanism. For carpets with short textiles the brush should in the lower position. Turn the knob to the left (when you are placed in front of the machine) to lower the brush. For carpets with longer textiles the brush should in a higher position. Turn the knob to the right (when you are placed in front of the machine) to set the brush at a higher level. If the red light comes on, slowly turn the knob in the opposite direction until the light goes off (Dual-versions only). If the red light (8) stays on continuously, there may be debris wrapped around the brush, during operation. [. . . ] These machines are not designed for picking up hazardous - i. Disconnect the power cord from the electrical outlet. Remove the cover with the filter, from the cleaner. Remove the used and dirty exhaust filter. [. . . ]