User manual NILFISK HDS 2000

[. . . ] Should damage occur to electrical or mechanical parts, the cleaner and / or accessory should be repaired by a competent service station or the manufacturer before use in order to avoid further damage to the machine or physical injury to the user. Do not leave the machine when it is plugged in. Unplug from the socket when not in use and before maintenance · Do not use with damaged cord or plug. to unplug grasp the plug , not the cord. [. . . ] Wipe the float valve and float basket with a damp cloth before the motor top is reinstalled to the container. The machine is equipped with a float system that shuts off the airflow through the machine when the maximum liquid level is reached. Never pick up liquid without the float body in place. To control: Loosen the two latches at each side of the motor top . Make sure that the switch/switches is located in direction towards the suction inlet. Then tighten both latches so that the motor top is properly secured. Always use a chemical defoamer when picking up water containing foaming detergents. Detach the drain hose from the bracket by pulling hose backwards from the cleaner. Place the drain hose end near a floor drain and then remove the plug at hose end. The natural pressure will then drain the liquids from the container. 2g) Emptying from the container: Pull the upper parts of the latches outwards and release the motor top. Shake filter so that all dust is removed from the filter. The new bag is fitted by passing the carboard piece with the rubber membrane through the vacuum inlet. make sure that the rubber membrane is passing past the heightening at the vacuum inlet. After emptying: Put back the motor top to the container. Make sure that the switch/switches is located in direction towards the suction inlet. Never pick up dry material without sackfilter or dustbag fitted in the machine. The suction efficiency of the vacuum cleaner depends on the size and quality of the filter and dust bag. Therefore - use only Original filter and dust bags. Remove the plug from the socket before performing maintenance. Always empty and clean the container and the float system after picking-up liquids. Turn the motor top to upside down position. [. . . ] Some variants have special storage places for accessories. THIS VACUUM CLEANER is designed, developed and rigorously tested to function efficiently and safely when properly maintained and used in accordance with the following instructions. These instructions have been prepared with safety and efficiency paramount. THE MACHINE OPERATOR must be trained by a suitably qualified instructor and must understand these instructions for use, and be made aware of any relevant regulations and legislation in force at the time of use. [. . . ]