User manual NILFISK IVB-3M

[. . . ] Directive 98/37 EC and further updatings define an "OPERATOR" as the person or people responsible for the installation, functioning, setting, maintenance, cleaning, repairing and transportation of the machine. Nilfisk-Advance declines all responsibility for problems, failures, accidents etc. This chapter contains a few warnings to ensure correct machine use and to avoid injury to operators and material damage. These warnings which should be thoroughly understood in order to carry out the operations correctly will be explained into details in the relevant chapters. [. . . ] ­ ­ Make sure the machine has been inspected before delivery (check the warranty). Check that the machine has not suffered any damage during transportation and carry out the preliminary operations for setting the machine at work according to the instructions in the manual. It consists of a sweeping roller whose rotation is operated by a hydraulic motor and whose lifting and lowering are operated by a hydraulic cylinder. ­ ­ ­ Pneumatic wheels Superelastic wheels They are independent, fastened to the frame by means of a hub with built-in brake drum. A hydrostatic variable delivery pump with servoassisted control supplies a drive hydraulic motor for forward and reverse gear. All circuits are protected by suction filters and safety valves. The mechanical components of the machine are suitably sized, according to a 1. The hopper is fitted on the front side of the machine and connected to the frame by means of a hinge. A hydraulic cylinder lifts and overturns the hopper when the waste is to be dumped at a height. The lower part has a hinged skirt, operated by a hydraulic cylinder, which closes the hopper while the waste is being dumped. the front side has a fan operated by a motor. NOTE Machines with the EC marking are provided with safety devices should the operator leave the driver's seat. The machine cannot be started unless the operator is sitting in position. ­ ­ ­ ­ ­ Before starting the machine, make sure the parking brake (5, Fig. Turn the ignition key clockwise to the first position. Battery charge and oil pressure warning lights should be on. Turn the ignition key clockwise until "Engine start" position is reached. When the engine is on, release the ignition key which will automatically return to the first position. When the engine is on, release the starting device. NOTE Before trying to start the machine again, turn the ignition key back to "0" position. As soon as the machine has been started, check the battery charge and oil pressure warning lights are off. ­ Stop the brooms by moving the central lever back to the central position. [. . . ] Do not remove the reference numbers from the cables and terminal boards. If the main broom is left rotating for a few minutes when the machine is stationary, the print left on the ground is useful to adjust the broom itself. ­ If the print size is less then 40 mm or more than 100 mm, adjust the spring pressure with the mounting screw (1, Fig. The seal should touch the ground lightly and evenly. [. . . ]