User manual NILFISK IVB 5-M

[. . . ] If you suspect the gasket between the motor head and the filter chamber is not sealing properly: 1. Turn on the unit and inspect the seal between the motor head and filter chamber. If you suspect the gasket between the filter chamber and the collection can is not sealing properly: 1. Loosen the screws "A" that lock filter chamber "B" against the vacuum structure. [. . . ] Plug the vacuum cleaner into an approved power source. Turn off the vacuum cleaner by rotating the main switch back to the "OFF" position (Figure 1). If the performance of the vacuum cleaner decreases during use, it may be necessary to clean the primary filter: 1. Turn off the vacuum and disconnect the vacuum from its power source. Repeat this several times to shake the dirt from the primary filter. Wait a few minutes for the dust to settle at the bottom of the container. Turn off the vacuum and disconnect the vacuum from its power source. Slide the container out from the machine and carry the container by the handle (figure 4). Pull off the screen surrounding the three posts. Remove old HEPA cartridge by carefully pulling cartridge through the posts. If the vacuum cleaner should malfunction or break down, grounding provides a path of least resistance for electric current to reduce the risk of electrical shock. This vacuum cleaner must be properly installed and grounded in accordance with all local codes and ordinances. DANGER: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Use only with certified explosion-proof plugs and outlets. This equipment is only certified for explosion-proof operation if it is equipped with the proper conductive hose and tools. Any alteration to this equipment by a third party will nullify its certification. Nilfisk warrants that its equipment will be free of defects in workmanship or material for a period of two years from the date of delivery. If the vacuum fails to meet these warranty standards, Nilfisk shall, upon notification within such time period, correct such non-conformity, at its option, either by repairing any defective part or parts, or by replacing a part or parts provided that the equipment is returned to an authorized Nilfisk service facility. in all cases freight both ways will be at expense of the customer. [. . . ] Equipment shall not be returned without advance notice to, and consent of Nilfisk. Correction of non-conformities or defects in the manner and for the period of time provided above, shall constitute fulfilment of all Inabilities of Nilfisk to the customer, whether based on contract, negligence or otherwise with respect to, or arising out of such equipment. The remedies set forth herein are exclusive, and the inability of Nilfisk with respect to this sale or anything done in connection therewith, whether in contract, in tort, under any warranty, or otherwise, shall not, except as expressly provided herein, exceed the price of the equipment or part on which such liability is based. This warranty does not cover repairs due to normal wear and tear, accident, neglect, misuse or abuse, incorrect installation or use other than as described in the instruction booklet. [. . . ]