User manual NILFISK P 150.1

[. . . ] Nilfisk P 130. 1/150. 1/160. 1 Nilfisk P 130. 1/150. 1/160. 1 X-TRA User Manual 128303204 c Printed in China Copyright © 2010 Nilfisk, Division of Nilfisk-Advance A/S We congratulate you on your new Nilfisk High Pressure Washer We are confident that the new high pressure washer of Nilfisk will justify your expectations of quick and effective cleaning. Now you have a cleaning device which will facilitate your future cleaning tasks and make them more effective. Many tasks which were previously difficult, can now be solved in a few minutes and with a much better result. If, contrary to expectations, problems should arise which cannot be remedied by means of the information in section 8. 0, the Nilfisk service organization will be at your disposal. [. . . ] Attach the nipple of the high pressure hose to the spray gun quick coupling. Mount the nozzle or any other equipment you want to use. Connect the machine to the water and power supplies. 5 Operating Instructions Separate detergent container 1. Remove the cover with suction hose from the detergent container. Mount the cover with suction hose on the separate detergent container. EN like, an external suction filter should be mounted. For further information, please contact your nearest Nilfisk distributor. 2. 7 End of operation 1. Stop the machine by turning the start/stop switch (2) to pos. Shut off the water supply and activate the trigger (6a) to relieve the machine of pressure. Concerning storage, please refer to section 5. 0. The cover has a standard thread and fits common detergent containers. If your container does not have a standard thread, detach the filter from the suction hose and remove the cover. Extra detergent hose can be pulled out of the machine. 2. 5 Regulation of pressure / water volume This function is not available on model B. Working pressure and water volume can be regulated on the machine by turning the button for regulation of pressure / water volume (14). The pressure can be read on the pressure gauge (13). 2. 6 Suction mode The machine can take in water from a rain water butt as an example. In the suction mode, the inlet hose must be filled with water before starting up the machine. The water inlet hose must not be too long, approx. Make sure that the water butt is not placed on a lower level than the machine. Attach the water inlet hose to the machine and place the other end of it in the water butt. Detach the spray lance and activate the trigger of the spray lance. Keep the trigger activated until water has come out for approx. Remount the spray lance and the machine is ready for operation. NOTE: The internal filter of the machine is not intended for the filtration of large quantities of impurities. If the water contains leaves, sand or the 6 3. 0 Accessories Standard Equipment Only use original accessories. [. . . ] malfunctions due to Possible Causes mentioned in section Troubleshooting Chart of the instruction manual). EN 10 6 6a 6b 7 9 5 15 16 10 2 11 13 1 14 8 12 4 3 GERMANY Nilfisk-ALTO Division of Nilfisk-Advance AG Guido-Oberdorfer-Str. 10 89287 Bellenberg Tel. : (+49) 180 5 37 37 37 E-mail: info. de@nilfisk-alto. com POLAND Nilfisk-Advance Sp. 3-go MAJA 8 Tel. : +48 22 738 37 50 PORTUGAL Nilfisk-Advance Sintra Business Park Zona Industrial Da Abrunheira Edificio 1, 1° A P2710-089 Sintra Tel. : +35 121 911 2670 E-mail: mkt. pt@nilfisk-advance. com http://www. nilfisk-advance. com HEAD QUARTER DENMARK Nilfisk-Advance Group Sognevej 25 DK-2605 Brøndby Tel. : (+45) 4323 8100 E-mail: mail. com@nilfisk-advance. com GREECE Nilfisk-Advance SA 8, Thoukididou str. 164 52 Argiroupolis Tel. : +30 210 911 9600 E-mail: nilfisk-advance@clean. gr HOLLAND Nilfisk-Advance Versterkerstraat 5 1322 AN Almere Tel. : (+31) 36 546 07 00 E-mail: info. nl@nilfisk-advance. com RUSSIA SALES COMPANIES ARGENTINA Nilfisk-Advance srl. [. . . ]