User manual NILFISK P 160.2 X-TRA

[. . . ] Before starting up your machine please check it carefully for any defects. If you find any, do not start up your machine 62 Especially check: The insulation of the electric cable should be faultless and without any cracks. never direct the water jet at persons , pets , live electrical equipment or the machine itself. Never try to clean clothes or footwear on yourself or other The operator and anyone in the immediate vicinity of the site of cleaning should take action to protect themselves from being struck by debris dislodged during operation. [. . . ] Front position is to be used if the product is used together with a special wall hook for wall storage. Screw the quick coupling tight on to the water inlet (2). Note: The inlet filter must always be fitted in the water inlet pipe to filter out sand, limestone and other impurities as these will damage the pump valves. 1 Connection of high pressure hose Machines without hose reel: Attach the high pressure hose (4) to the high pressure connection of the machine (3). Machines with hose reel: Unwind the high pressure hose completely. Pull the blue quick-release grip (A) of the spray gun backwards. Insert the nipple of the spray lance (B) into the quick-release connection and release it. Pull the spray lance (or other accessory) forwards to check that it is securely attached to the spray gun. Always remove any dirt from the nipple before connecting the spray lance to the spray handle. If there is a risk of silt, sand or sediment in the inlet water (i. From your own well), an additional filter should be mounted. Let the water run through the water hose before connecting it to the machine to prevent sand and dirt from penetrating the machine. Note: Check that the filter is fitted in the water inlet pipe and that it is clean and free from debris. Connect the water hose to the water supply by means of the quick connector (inlet water, max. To raise or lower the handle, press the button (16) and move the handle upwards or downwards. When a click is heard, the handle is in right position. The spray lance is affected by a thrust during operation - therefore always hold it firmly with both hands. NOTE: Do not place the machine in tall grass!Activate the trigger of the spray handle and let the water run until all air has escaped from the water hose. Always adjust the distance and thus the pressure of the nozzle to the surface, which is to be cleaned. Do not cover the machine during operation. Note: If the machine is left or not used for 5 minutes, it must be switched off on the start/stop switch "O" (1): 1. [. . . ] Carefully loosen the filter with a pair of pliers and clean it. check that it is intact before re-mounting it. The inlet filter must always be fitted inside the water inlet pipe to filter out sand, limestone and other impurities, as they will damage the pump valves. A clogging up in the nozzle causes a pump pressure which is too high. [. . . ]