User manual NILFISK POSEIDON 4

[. . . ] 38-41, 98-103 Instrues de operao . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42-45, 98-103 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 46-49, 98-103 letme klavuzu . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50-53, 98-103 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Do not direct the jet towards yourself or towards other persons in order to clean clothes or footwear. During operation of the cleaner, recoil forces are produced at the spraying device and, when the spray lance is held at an angle, a torque is also created. The spraying device must therefore be held firmly in both hands. Do not use the cleaner when other people without protective clothing are in the working area. Check that cleaning will not result in dangerous substances (e. g. asbestos, oil) being washed off the object to be cleaned and harming the environment. Do not clean delicate parts For your own safety Before using the high-pressure cleaner, be sure to also read the enclosed operating instructions and keep them within reach at all times. The appliance must only be used by persons, who have been instructed in its correct usage and explicitly commissioned with the task of operating it only be operated under supervision not be used by children General Use of the high-pressure cleaner is subject to the applicable local regulations. Besides the operating instructions and the binding accident prevention regulations valid in the country of use, observe recognised regulations for safety and proper use. Do not use any unsafe work techniques. Transport Transport of the high-pressure cleaner is easy on its large wheels. For safe transport in and on vehicles we recommend to prevent the equipment from sliding and tilting by fixing it with belts. Transport (when tilted): do not tilt the machine on the front with the water connections. 2 POSEIDON 4 made of rubber, fabric, etc. Keep some distance between high pressure nozzle and surface in order to prevent the surface from damage. Do not use the high-pressure hose for lifting loads. The maximum permissible working pressure and temperature are printed on the high-pressure hose. Do not continue to use the cleaner if the mains power lead or high-pressure hose is damaged. Do not cover the cleaner or operate it in inadequately ventilated rooms!Never operate the cleaner without water. Even brief shortages of water result in severe damage to the pump seals. or tug the power cord). Never spray electrical equipment with water: danger for persons, risk of short-circuiting. The cleaner may only be connected to a correctly installed plug socket. Switching on the cleaner may cause voltage fluctuations. [. . . ] Clean/replace the high pressure nozzle Set the required working pressure Top up detergent tank or set detergent metering to "0" Check that the suction set is air-tight Open water tap Use specified water inlet hose Clean the water filter in the water connection (never work without water filter) > > > High pressure nozzle blocked worn Pressure control on the spray pipe is not set correctly Detergent tank empty Pressure fluctuations > > > > Pump draws in air (only possible in suction mode) Lack of water Water inlet hose is too long or its cross-section too small Lack of water caused by blocked water filter > Lack of water because max. permissible suction height has not been heeded See instructions The motor does not start when the cleaner is switched on > The plug is not inserted prop- erly, i. e. there is no current Check the plug, lead and switch and if necessary have them replaced by a trained electrician Switch on the mains fuse > The mains fuse is switched off Recycling the cleaner Make the old cleaner unusable immediately. Unplug the cleaner and cut the power cord. [. . . ]