User manual NILFISK SALTIX 3

[. . . ] Use of non original dust bags or non original filters can cause restricted air flow which may lead to machine overload. using non-original dust bag or filters will void the warranty. Only use this vacuum cleaner with the equipment and nozzles supplied with the cleaner. The use of other non original nozzles can impair security. [. . . ] Young children should be supervised to ensure that they do not play with the appliance. No changes to the mechanical, electrical or thermal safety devices must be made. This machine is equipped with a thermal cut-out to protect the motor and other vital machine parts from overheating. Should the machine cut out, you will have to wait at least 5-10 minutes for it to automatically reset. While you are waiting, switch the machine off and unplug it, then check the hose, dust bag and filter to be sure that nothing is blocking the flow of air through the machine. Recycling the vacuum cleaner As specified in European Directive 2002/96/EC on old electrical and electronic appliances, used electrical goods must be collected separately and recycled ecologically. Contact your local authorities or your nearest dealer for further information. Rated power Protection grade (moist, dust) Protection class (electrical) Airflow with hose and tube Vacuum, at nozzle Suction power with hose Sound power IEC 704 2. The equipment meets the requirements in EN 61000-3-11, and connection to the public mains is possible following consultation with the power supplier. The equipment may only be connected to the mains with a network impedance that is below 0. Network impedance at the point of delivery can be obtained from the power supplier. If the mains has a higher network impedance, momentary drops in mains voltage may occur during start/operation of the equipment. This may also affect or disrupt the operation of other equipment, e. Specifications and details are subject to change without prior notice. THIS VACUUM CLEANER is designed, developed and rigorously tested to function efficiently and safely when properly maintained and used in accordance with the following instructions. These instructions have been prepared with safety and efficiency paramount. THE MACHINE OPERATOR must be trained by a suitably qualified instructor and must understand these instructions for use, and be made aware of any relevant regulations and legislation in force at the time of use. CAUTION - This machine is not suitable for use in explosive or inflammable atmospheres or where such atmospheres are likely to be produced by the presence of volatile liquid or inflammable gas or vapour. CAUTION - In no circumstances should the power supply cord be wrapped around fingers or any part of the operators person. CAUTION - The electrical supply plug must not be subjected to undue stress by pulling on the power supply cord. [. . . ] The plug thus cut off MUST BE DESTROYED for safety reasons before being disposed of. Machines built for other voltages and frequencies are not normally supplied with a fitted plug. If it is necessary to fit a plug, the wires in this power supply cord are coloured in accordance with the following code: If using a three-pin plug, do not make any connection to the the terminal in the plug which is marked with the letter `E' or by the safety earth symbol or coloured green or green & yellow. This machine is double-insulated and no earth connection is necessary. [. . . ]