User manual NILFISK SR 1000S MATERIAL COMPOSITION

[. . . ] Nilfisk will not be answerable for damages coming from the non-observance of this prohibition. The User Manual must be kept near the machine, inside an adequate case, away from liquids and other substances that can cause damage to it. The declaration of conformity, supplied with the machine, certifies the machine conformity with the law in force. NOTE Two copies of the original declaration of conformity are provided together with the machine documentation. [. . . ] For machine proper operation, the dust filter must be as clean as possible. To clean the dust filter while sweeping, turn on the filter shaker for a short interval by pressing the upper part of the switch (56), then turn on the vacuum system by pressing the lower part of the switch (56). While working, repeat the procedure every 10 minutes on average (depending on the dustiness of the area to be cleaned). NOTE This procedure can also be performed when the machine is moving. When the dust filter is clogged and/or the hopper is full, the machine cannot collect dust and debris anymore. The hopper (4) should be dumped after each working period and whenever it is full (see the procedure in the next paragraph). To empty it, move the machine close to the dustbin and proceed as follows: · Turn off the vacuum system with the switch (56). Always perform this procedure on a level floor to avoid machine unbalance. When lifting and emptying the hopper (4), engage the parking brake with the pedal (75) and the lever (68). Keep people away from the machine and from the hopper (4) especially. 1) can be dumped only when lifted at a minimum height of 270 mm. Perform step 1 again to check the proper adjustment of the main broom height. When the broom is too worn to be adjusted, replace it as shown in the next paragraph. nOTE If it is not possible to adjust the print (A , Fig. 3) properly, because the pressure on the floor at the ends of the broom is different, refer to the Service Manual. NOTE Brooms with harder or softer bristles are available. It is advisable to wear protective gloves when replacing the main broom because there can be sharp debris between the bristles. Drive the machine on a level floor and engage the parking brake with the pedal (75) and the lever (68). Turn the ignition key (69) to "0" and remove it. 8) is free from dirt or foreign materials (ropes, rags, etc. The new main broom must be installed with the bristles rows (B, Fig. NOTE Brooms with harder or softer bristles are available. [. . . ] If necessary, top up through the caps (24). Leave the caps (24) open for the next battery charge. If necessary, clean the upper surface of the batteries. After charging, disconnect the battery charger from the electrical mains and from the connector (25). [. . . ]