User manual NILFISK STEAMTEC BROCHURE

[. . . ] distilled water extends the service life of the cleaner. Cleaning agents, scents, solvents and other chemical substances may damage the cleaner and may be a risk to health. Regularly check whether the steam hose and power cord are damaged or show signs of age. Only use the cleaner if the steam hose and power cord are intact. [. . . ] avoid contact with hot cleaner surfaces , emerging water and steam. The pressure tank is under pressure during operation. For this reason, never open the safety catch during operation. Be careful particularly during the following work as there may still be hot steam in the cleaner: ­ Opening the safety catch. The safety catch has a pressure relief hole. Open the safety catch by one or two turns. To prevent the cleaner from being used inadvertently during work breaks, switch off the cleaner and pull out the mains plug. Allow the cleaner to cool down completely before storing it or opening the safety catch. Always unwind cord from the reels completely to prevent the power cord overheating. Extension cords are not recommended, however if necessaray refer to the following recommendations: Always remove the plug from the power supply before cleaning or carrying out maintenance work on the cleaner. carry out only the maintenance operations described in the operating instructions. As specified in European Directive 2002/96/EC on old electrical and electronic appliances, used electrical goods must be collected separately and recycled ecologically. Voltage fluctuations should not occur if the impedance at the transfer point is less than 0. 15If in doubt ask your local electricity supplier. Marble: Never clean marble directly with the floor nozzle without a cloth. It may be necessary to clean marble floors several times to completely remove old cleaning agents and grease stains. Select a low steam setting for this cleaning job. For daily cleaning stretch a fresh, clean cloth over the floor nozzle and secure it with the fastening clamps. slide the floor nozzle gently over the floor. To use all of the cloth as far as possible, you can move it on the floor nozzle or reverse it. If the dirt is stubborn, you may clean the floor directly with the fold out brush without a cloth. the bristles loosen the dirt from the crevices and remove it. [. . . ] The window wiper is very efficient to clean areas covered with tiles. To clean sanitary installations, use the jet nozzle with or without the round brush. Use a sponge or kitchen paper to remove excessive moisture and remaining dirt. blinds: Use the small round nylon brush. [. . . ]