User manual NILFISK TURBO D

[. . . ] Use the cleaner only when the mains lead is in a good and safe condition. The following materials must not be picked up with the cleaner: _ Hot materials (glowing cigarettes, hot ashes, etc. APPLIANCE PLUG SOCKET Before connecting any appliance to the appliance plug socket, the cleaner must always be switched off. DURING OPERATION Take care not to damage the mains lead (e. [. . . ] The design of the unit corresponds to the following pertinent regulations: Applied harmonised standards: INTENDED USE The Wap turbo D can be used for all cleaning operations in commerce, crafts and industry. Thanks to its wide range of accessories, it can be used for a large number of applications. The machine can be classified and used as an industrial vacuum cleaner to utilization category "C" when employed in accordance with its intended use for picking up non-flammable, dry dusts with TLV ratings and carcinogenic substances from groups II and III (see Hazardous Substances Regulations, Annex II, No. Concentration of a substance as gas, vapour or particulate in the air at the place of work which generally does not impair the health of the employees and does not disturb the employees to any considerable extent. The two-layer filter material of the bag-type safety filter has been tested by the BIA in accordance with ZH 1/487 para. Sturdy, powder-coated chassis, large wheels, steering rollers with parking brake and large-volume stainless steel container. 2-layer bag-type safety filter with disposal sleeve for dust-free disposal. Possibility of using 2layer bag-type filter for disposal of dusts with TLV ratings > 1 mg/m3. Safety equipment for preventing or eliminating hazards must be serviced regularly in accordance with 39 () VBG and its safety and proper function inspected at least once per year. The safety inspection must be performed by the Wap Service department. Ensure that the mains lead is not damaged by being driven over, pinched or dragged, etc. inspect the mains lead regularly for signs of damage and/or ageing. The cleaner must not be used if the mains lead is not in perfect condition. When using or replacing the mains lead, the type H07RN-F 4G 1. 5 mm² specified by the manufacturer must be used. The replacement of the mains lead may only be carried out by an authorised person. The cleaner must be protected with a 16 A (Ttype) fuse. The dust collecting container must be cleaned as required, but always after use. SAFETY MEASURES The cleaner should only be used by persons trained in its use and expressly authorised to use it. Do not clean without the filter cartridge! this would cause damage to the turbine!Furthermore, health risks cannot be ruled out if the cleaner is operated without a filter! [. . . ] REPLACEMENT OF FILTER CARTRIDGE Before replacing the filter cartridges (main filter), the cleaner should be switched off for approx. 5 minutes to allow the remaining dust to settle. Procedure: a) Lift the hood with the filter cartridges from the dust container and turn upside down. B) Push back the spring steel brackets from the filter cartridges. [. . . ]