User manual NITECORE EC25

[. . . ] Please refer to the “Power Tips” section of this manual for details. WARNING Ensure batteries are inserted with the positive (+) end pointing to the head. The EC25 will not operate with incorrect installation. Accessories Quality holster, lanyard, spare O-ring General Operation Nominal voltage Battery Options Primary Lithium battery 18650 Rechargeable Li-ion battery Rechargeable Li-ion battery SIZE Compatible Y (Recommended) Y (Recommended) Y CR123 18650 RCR123 3V 3. 7V 3. 7V The EC25 utilizes a 2-stage switch similar to a camera shutter button. The light’s numerous functions are selected according to the depth the switch is pressed. [. . . ] To cycle between high and turbo modes press the button partway down while in turbo mode. To turn the light off when in turbo mode, once again press the button all the way down and release within one second. Turbo / search mode has a momentary function which allows the light to be turned on only when the switch is held. Pressing the switch all the way down and holding will activate Turbo / Search mode’s momentary function. The light will turn off the moment the switch is released. NB: For user safety and to prevent overheating / failure, the EC25 will automatically switch to high mode after three minutes of use in Turbo mode. Half press and hold the switch to re-activate Turbo. Output & Runtime TURBO HIGH MID LOW LOWER LUMENS 860 LUMENS 540 2h LUMENS 285 LUMENS 120 LUMENS 60 NOTICE Stated data has been measured according to the international flashlight testing standards ANSI/NEMA FL1 using a quality Nitecore 18650 (3. 7V 2600mAh) battery or two Nitecore CR123 (3V 1550mAh) batteries under laboratory conditions. The data may vary due to individual usage habits and environmental conditions. NITECORE (SYSMAX) is a member of PLATO, participating in and helping to develop the ANSI FL1 standard of measurement. Product testing data is in accordance with these internationally recognized scientific standards. 1×18650 2×CR123 1h30min 4h15min 10h30min 4h 9h 25h 17h30min 1h30min 1h45min 222m (Beam Distance) 12500cd (Peak Beam Intensity) 1. 5m (Impact Resistant) IPX-8, 2m (Waterproof AND Submersible) Thanks for purchasing NITECORE! ® ALL-ROUND Flashlight Expert Standby Mode / Lockout and Unlock functions Changing With the light turned on, press the switch all the way down and release within one second to enter into standby mode. In this mode, the light will consume small amounts of power to maintain the settings in the MCU (micro control unit) but appear to be turned off. When in standby mode the power indicator light will flash once every three seconds to show the location of the light. With the light turned on, press the switch all the way down and hold for more than one second. The light will turn off and enter into lockout mode. Lockout mode consumes almost no battery power and prevents the light from accidentally being turned on. Holding the switch for more than one second to exit the lockout mode. NB: When entering lockout mode, the power indicator will flash to indicate specific battery voltage. Please refer to the “Power Tips” section of this manual for details. When the power indicator blinks rapidly it means the batteries need to be replaced. [. . . ] The product(s) is/are damaged by leakage of batteries. For the latest information on NITECORE® products and services, please contact your national NITECORE® distributor or send an email to service@nitecore. com Power Tips 1. When the light is on, the power indicator will blink once every two seconds when power levels reach 50%. When the light is on, the power indicator will blink consistently when power levels are low. [. . . ]