User manual NOKIA 101

[. . . ] Nokia 101 User Guide Issue 1. 0EN Keys and parts 1 ct Sele 2 k Bac 8 3 7 6 5 5 6 7 8 4 1 2 3 4 Earpiece Screen End/Power key Keypad Microphone Scroll key Call key Selection keys 13 9 10 12 11 9 10 11 12 13 Charger connector Flashlight Memory card slot Loudspeaker Headset connector Insert the SIM card and battery 1 Slide the back cover down. 4 Close the SIM card holder. 2 Open the SIM card holder. 5 Slide SIM2 under the metal part. 3 Insert SIM1. 6 Make sure the plastic tab holds the SIM card in place. Insert a memory card 7 Line up the contacts. 1 Open the cover of the memory card slot. See vi) in General information. 8 Push the battery in. 2 Make sure the contact area is facing up, and push the card in. 9 Slide the back cover up. 3 Close the cover. Charge the battery Switch on 2 seconds 1 Connect the charger to a wall outlet. 1 Press and hold the power key . Dual SIM 1 2 SIM1 SIM2 OK 2 Connect the charger to the phone. 2 Set which SIM card to use. See v) in General Information. 09:00 OK Back 3 The phone indicates a full charge. You can use the phone while charging. 3 To set the hour, press up or down. [. . . ] Crossed-out wheeled-bin symbol taken to separate collection at the end of their working life. This requirement applies in the European Union. Do not dispose of these products as unsorted municipal waste. For more environmental information, see the product Eco profile at www. nokia. com/ ecoprofile. Batteries and chargers Battery and charger information Your device is intended for use with a BL-5CB rechargeable battery. Nokia may make additional battery models available for this device. This device is intended for use when supplied with power from the following chargers: AC-3. The exact Nokia charger model number may vary depending on the plug type, identified by E, X, AR, U, A, C, K, or B. The battery can be charged and discharged hundreds of times, but it will eventually wear out. When the talk and standby times are noticeably shorter than normal, replace the battery. Battery safety Always switch the device off and disconnect the charger before removing the battery. When you unplug a charger or an accessory, hold and pull the plug, not the cord. When your charger is not in use, unplug it from the electrical plug and the device. Do not leave a fully charged battery connected to a charger, as overcharging may shorten the battery's The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be lifetime. If left unused, a fully charged battery will lose its charge over time. Always keep the battery between 15°C and 25°C (59°F and 77°F). Extreme temperatures reduce the capacity and lifetime of the battery. A device with a hot or cold battery may not work temporarily. Accidental short-circuiting can happen when a metallic object touches the metal strips on the battery, for example, if you carry a spare battery in your pocket. Short-circuiting may damage the battery or the connecting object. Do not dispose of batteries in a fire as they may explode. Dispose of batteries according to local regulations. [. . . ] The exposure guidelines for mobile devices employ a unit of measurement known as the Specific Absorption Rate or SAR. The SAR limit stated in the ICNIRP guidelines is 2. 0 watts/ kilogram (W/kg) averaged over 10 grams of tissue. Tests for SAR are conducted using standard operating positions with the device transmitting at its highest certified power level in all tested frequency bands. The actual SAR level of an operating device can be below the maximum value because the device is designed to use only the power required to reach the network. [. . . ]