User manual NOKIA 9600S

[. . . ] Owner's Manual MEDIAMASTER 9200 S 9600 S GB 1 Important Information Wiring the plug (UK and Eire only) The mains lead on this product is already fitted with a non-rewireable (moulded) plug incorporating a fuse, the value of which is indicated on the pin face of the plug. Should the fuse need to be replaced, an ASTA or BSI approved BS 1362 fuse must be used of the same rating, marked thus: If the fuse cover is detachable always refit the cover after replacing the fuse. NEVER use the plug with the fuse cover omitted. If the fitted plug is not suitable for your socket outlets it should be cut off, after having first removed the fuse, and an appropriate plug fitted in its place. [. . . ] When you have finished the settings in this menu, press the "OK" button to continue with the "Channel Search Set-Up" described on the next page. 4 way DiSEqCTM switch GB 14 Channel Search set-up The information to enter in this menu is available in various magazines covering satellite TV reception, or from your Service Provider. if you later want to add channels from a new transponder. Antenna Configuration: Select the option, 1 - 8, that corresponds to your antenna system. Transponder Frequency: Enter using the number buttons on the remote control. Polarization: Select polarization; "Horizontal" or "Vertical". Symbol Rate: Select "Auto" or enter with the number buttons. FEC: Enter the appropriate Forward Error Correction (FEC) value. Network Search: Select "YES" to search from all transponders used by a specific Service Provider. ("YES" is the default setting). Select "NO" to search only from the transponder that you have entered on line "Transponder Frequency". (Useful if you do not want to search through all transponders for a specific Programme Distributor). By pressing the OK button you can now enter the menu from where the Mediamaster starts to search for channels from the satellite. SMATV or IF frequency channel search Model 9200 S only A SMATV network is commonly found in smaller block of flats. In such a network you will have access to a central antenna system. If the Mediamaster is connected to a SMATV network, select "SMATV or IF frequency search". Pressing the OK button will give a menu where you can enter different values for "Symbolrate" and "FEC". However, the most common alternatives for "Symbolrate" and "FEC" are already preprogrammed. (You only have to make changes here in exceptional cases). Just press the OK button once again, and the "Channel Search" procedure will start; Refer to "Channel Search" on page 12. GB 15 Viewing TV Important general information The following will describe the basic functions of your Mediamaster during the watching of TV or listening to Radio channels from the Mediamaster. Sometimes the information may not be displayed as illustrated. Many of the functions described here are dependent on the Service Provider and/or can only be used if they are included in the transmitted programme information. Please note, that during the Channel Search procedure, the Mediamaster has downloaded ALL available channels. [. . . ] Mediamasters, video recorders and TV sets. Also named Euroconnector or Peritel connector. SI Service Information EPG Electronic Programming Guide, programme information about name, starttime etc. FEC Forward Error Correction, parameters given by e. g. [. . . ]