User manual NOKIA AD-42W

[. . . ] Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with the Nokia dealer nearest to you. 2 © 2006 Nokia. All rights reserved. Unauthorized changes or modifications to this device may void the user's authority to operate the equipment. [. . . ] The use of any other types may 4 invalidate any approval or warranty, and may be dangerous. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. © 2006 Nokia. All rights reserved. Switch the gateway on or off To switch on, plug the charger cable into the power connector at the back, and connect the charger to a wall outlet. When the gateway is connected to a paired audio device and is ready for use, the indicator light flashes slowly. The gateway tries to connect to the Bluetooth device that you have used most recently in the current operating mode. For more information on the two operating modes, see "Pair the gateway". To switch off, unplug the charger from the wall outlet and the gateway. Pair the gateway Before you can use the gateway with a compatible audio device that supports Bluetooth wireless technology, you need to pair the gateway with it. To pair the gateway with a music player (such as a music player device or a mobile phone with a music player feature), do as follows: 1. Check that the operating mode key is in the down position. Press and hold the pairing key until the indicator light is continuously shown. Use your music player or phone to search for and select the gateway and to enter the Bluetooth passcode 0000. If the pairing was successful, the indicator light flashes quickly 10 times. To pair the gateway with a headset, do as follows: 1. Check that the operating mode key is in the up position. Set up the headset for pairing as instructed in the user guide for the headset. Press and hold the pairing key until the indicator light is continuously shown. The gateway is paired automatically with the headset. If the headset requires a Bluetooth passcode and the default passcode of the headset is not 0000, change the passcode to 0000 as instructed in the user guide of the headset. You can pair the gateway with up to eight Bluetooth devices but connect it to only one device at a time in both operating modes. To change the Bluetooth audio device (such as a music player or headset) that you have connected to the gateway, disconnect the current device from the gateway and connect another paired device to it. For details, see the user guides of your audio devices. If you want to clear the list of paired devices, press and hold the pairing key for 15 seconds while you are not listening to music through the gateway. Connect the gateway Ensure that the home stereo system is switched off before making any connections to it. [. . . ] · Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards. · Do not attempt to open the device. · Do not drop, knock, or shake the device. [. . . ]