User manual NOKIA AD-5B

[. . . ] Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with the Nokia dealer nearest to you. Contents 1. [. . . ] Select the PIN entry mode by pressing once the Control key in the Wireless Audio Adapter to make the adapter find the compatible headset. If a compatible headset is found, the light indicator in the adapter is continuously green for 20 seconds. During that time you need to start keying in the Bluetooth passkey on the phone keypad. Copyright © 2003 Nokia. All rights reserved. 7 If there are no headsets with compatible Bluetooth wireless technology within a 10 metre range, the light indicator blinks red to indicate an error situation. The adapter then goes into Init mode and blinks slowly a red light. See Modes of the light indicator on page 10. When the light indicator on the Nokia Wireless Audio Adapter is continuously green, you can key in the four-digit Bluetooth passkey on the phone to pair the headset. The digits are shown on the phone display. The Bluetooth passkey is marked on the card that is provided in the sales package of the headset. If the pairing is successful, the phone display is cleared. The light indicator on the Nokia Wireless Audio Adapter is turned off and appears on the phone display. The headset, whose passkey you enter first, becomes the default device for the Wireless Audio Adapter. The Wireless Audio Adapter and the headset are now ready to be used. Note that all audios, including the call alert tones, are now routed to the headset. If the pairing is unsuccessful, either press the Control key once briefly or detach the adapter from your phone, and start the pairing procedure again from step one above. Copyright © 2003 Nokia. All rights reserved. 8 Pairing multiple headsets To pair another headset to the adapter, just repeat the procedure above. However, make first sure that the headset that has already been paired is turned off, and that only the new unpaired headset is within a 10 metre range of the adapter. Note that the adapter can be simultaneously paired with two headsets only. When using the headsets, the adapter first tries to find the default user, which is the first paired headset, and then the secondary headset. If you want to pair more headsets, the new headset replaces the secondary user. You can replace the secondary user as many times as you want. If you want to replace the default user, you need to reset the adapter. [. . . ] · Do not store the device in cold areas. When it warms up (to its normal temperature), moisture can form inside, which may damage electronic circuit boards. · Do not attempt to open the device . · Do not drop, knock or shake the device . [. . . ]