User manual NOKIA BH-602

[. . . ] Nokia Bluetooth Headset BH-602 User Guide Issue 1 EN DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HS-91W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www. nokia. com/phones/ declaration_of_conformity/. 0434 © 2007 Nokia. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. [. . . ] Do not attempt to remove the battery from the headset, as you may damage the headset. Connect the charger to a wall outlet. Charging the battery for 15 minutes provides about 5 hours of talk time with the AC-4 charger. Charging the battery fully may take up to 45 minutes with the AC-4 charger. When the battery is fully charged, the indicator light turns green. Disconnect the charger from the headset and the wall outlet. The fully charged battery has power for up to 11 hours of talk time or up to 300 hours of standby time. However, the talk and standby times may vary with different compatible Bluetooth devices, usage settings, usage styles, and environments. To check the battery charge when the headset is not connected to a charger, briefly press the power key. When the indicator light is green (displayed for about 3 seconds), the charge level is sufficient. When the light is yellow, you 9 English 2. Connect the charger cable to the charger connector. The indicator light is red while charging. It may take a while before charging starts. If charging does not start, disconnect the charger, plug it in again, and retry. Get started may need to recharge the battery soon. When the light is red, recharge the battery. When battery power is low, the headset beeps at regular intervals, and the indicator light slowly flashes red. Switch the headset on or off To switch on, press and hold the power key until the headset beeps and the green indicator light is displayed. When the headset tries to connect to a paired device, the indicator light slowly flashes green. When the headset is connected to a paired device and is ready for use, the indicator light slowly flashes blue. If the headset has not been previously paired with a device, it automatically enters the pairing mode (see "Pair the headset, " p. To switch off, press and hold the power key until the headset beeps and the red indicator light flashes once. Pair the headset 1. Ensure that your mobile device is switched on. 10 Get started To pair the headset if it has been previously paired with another device, ensure that the headset is switched off, and press and hold the power key until the indicator light starts to flash blue quickly. Activate the Bluetooth feature on the mobile device, and set it to search for Bluetooth devices. [. . . ] To use these features, your mobile device must support the Bluetooth Hands-Free profile 1. 5, and call waiting must be set to on in your device. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime. If left unused, a fully charged battery will lose its charge over time. Leaving the device in hot or cold places, such as in a closed car in summer or winter conditions, will reduce the capacity and lifetime of the battery. [. . . ]