User manual NOKIA BLUETOOTH HEADSET BH-503

[. . . ] Nokia Bluetooth Stereo Headset BH-503 User Guide 9203664 Issue 1 EN DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HS-95W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www. nokia. com/phones/ declaration_of_conformity/. © 2007 Nokia. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. [. . . ] Connect the charger cable to the charger connector. The indicator light is red while charging. It may take a while before charging starts. If charging does not start, disconnect the charger, plug it in again, and retry. Charging the battery fully may take up to 1 hour and 15 minutes. When the battery is fully charged, the indicator light turns green. Disconnect the charger from the headset and the wall outlet. The fully charged battery has power for up to 13 hours of talk time, up to 10 days of standby time, or up to 13 hours of music playing time (or 75 minutes of music playing time with 20 minutes charging). However, the times may vary with different compatible Bluetooth devices, usage settings, usage styles, and environments. When battery power is low, the headset beeps at regular intervals, and the indicator light slowly flashes red. Recharge the battery. Switch the headset on or off Switch on To switch on, press and hold the multifunction key for about 2 seconds. The headset beeps, and the green indicator light is briefly displayed. When the headset tries to connect to the paired mobile phone or music player that you have last used with it, the indicator light slowly flashes green. When the headset is connected to a paired device and is ready for use, the indicator light slowly flashes blue. If the headset has not been paired with a device, it automatically enters the pairing mode (see "Pair and connect the headset, " p. If you connect the headset to a device but do not use it for a while, switch off the headset to save power. 7 Get started Switch off To switch off, press and hold the multifunction key for about 5 seconds. The headset beeps, and the red indicator light is briefly displayed. Pair and connect the headset Pair and connect the headset with a mobile phone that has a music player feature If your phone supports the A2DP Bluetooth profile and has a music player feature, you can use the phone to make and receive calls and to play music with the headset. If the headset has not been previously paired with a device, switch on the headset. The headset enters the pairing mode, and the indicator light starts to flash blue quickly. If the headset has been previously paired with another device, switch off the headset, and press and hold the multifunction key until the indicator light starts to flash blue quickly. Activate the Bluetooth feature on the phone, and set it to search for Bluetooth devices. [. . . ] The available music functions depend on your music player. Batteries may also explode if damaged. 12 Care and maintenance Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. [. . . ]