User manual NOKIA BLUETOOTH STEREO HEADSET BH-505

[. . . ] This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited. © 2009-2010 Nokia. Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation. Nokia tune is a sound mark of Nokia Corporation. [. . . ] The headset beeps, and the red indicator light is briefly displayed. If the headset is not connected to a device within about 30 minutes, it switches off automatically. ENGLISH Pair and connect the headset Before using the headset, you must pair and connect it to a compatible device. If your mobile device supports the A2DP Bluetooth profile and has a music player feature, you can use the device to also play music through the headset. If your mobile device does not support the A2DP profile, you can separately pair the headset with the mobile device and a music player that supports this profile. If you have paired and connected the headset to your mobile device, disconnect the headset from it before pairing the headset with the music player. To pair and connect the headset to your device if the device supports the Near Field Communication (NFC) feature, activate the feature, and use your device to touch the area shown in figure 10 at the start of this guide. For details on NFC, see the user guide of your device. To pair and connect the headset to your device if the device does not support NFC: 1. Ensure that your mobile device or music player is switched on and the headset is off. If the headset has not been previously paired with a device, switch on the headset. The headset enters pairing mode, and the blue indicator light starts to flash quickly. If the headset has been previously paired with a device, ensure that the headset is switched off, and press and hold the power key (for about 8 seconds) until the blue indicator light starts to flash quickly. ENGLISH 3. Within about 3 minutes, activate the Bluetooth feature on your device, and set it to search for Bluetooth devices. For details, see the user guide of your device. Select the headset from the list of found devices. If necessary, enter the passcode 0000 to pair and connect the headset to your device. If your device does not have a keypad, it may use this passcode by default. In some devices, you may need to make the connection separately after pairing. When the headset is connected to your device and is ready for use, the blue indicator light flashes slowly. You can pair the headset with up to eight devices but connect it to only one device supporting the HFP profile and another device supporting the A2DP profile at a time. To manually connect the headset to a last used device that supports the HFP profile (for example, after connection loss), switch the headset off and on, or press and hold the answer/end key for about 2 seconds. To manually connect the headset to a last used device that supports the A2DP profile, press the play/pause key. [. . . ] Paint can clog the moving parts and prevent proper operation. These suggestions apply equally to your device, charger, or any accessory. Recycle Always return your used electronic products, batteries, and packaging materials to dedicated collection points. This way you help prevent uncontrolled waste disposal and promote the recycling of materials. [. . . ]