User manual NOKIA MINI SPEAKERS MD-9

[. . . ] The speaker cable also serves as an FM radio antenna. Read this user guide carefully before using the speaker. Also, read the user guide for the device that you connect to the speaker. ENGLISH This product may contain small parts. [. . . ] During long periods where the speaker is not used, remove the batteries to prevent damage from battery leakage. Use the speaker Lift the audio plug from the slot at the bottom of the speaker, and uncoil the speaker cable. To connect the speaker to a compatible Nokia device that has a Nokia 3. 5 mm AV connector or a compatible device (such as a PC or music player) ENGLISH that has a standard 3. 5 mm audio connector, insert the audio plug into the connector in your device. To connect the speaker to a compatible Nokia device that has a Nokia 2. 5 mm AV connector, connect the appropriate adapter (if supplied) to the device and the audio plug to the adapter. To switch on the speaker, slide the power key to the ON position. To switch off, slide the power key to the OFF position. To listen to music when the speaker is connected to a compatible device, start the music playback on the device. To set the volume, use the volume controls on your device. If the sound level of the speaker becomes too low or you hear a continuous beep from the speaker, change the speaker batteries. Warning: Listen to music at a moderate level. Continuous exposure to high volume may damage your hearing. ENGLISH To attach a strap, open the battery cover, thread the strap through the hole at the side of the speaker so that the loop runs around the small pin (7), tighten the strap, and close the cover. To take the speaker with you, switch it off, coil the speaker cable, and insert the audio plug into the slot at the bottom of the device. Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, remove the batteries, and allow the device to dry completely before replacing them. · Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged. ENGLISH · Do not store the device in hot areas. [. . . ] For more environmental information, see the product Eco-Declarations at www. nokia. com/ environment. Always return your used electronic products, batteries, and packaging materials to a dedicated collection point. This way you help prevent uncontrolled waste disposal and promote the recycling of materials. [. . . ]