User manual NOKIA RC 9575

[. . . ] We recommend that you take the time to read this manual to take full advantage of the many features of your UPS. NOKIA UPS SYSTEMS pays great attention to the environmental impact of its products. Measures that have made Pulsar Evolution a reference in environmental protection include: The eco-design approach used in product development, recycling of Pulsar Evolution at the end of its service life. To discover the entire range of NOKIA UPS SYSTEMS products and the options available for the Pulsar Evolution range, we invite you to visit our web site at www. mgeups. com or contact your NOKIA UPS SYSTEMS representative. This manual contains important instructions for Pulsar Evolution Models that must be followed during installation, operation and maintenance of the UPS and batteries. [. . . ] Connector for an additional battery module. Six receptacles for direct connection of protected equipment. Two programmable receptacles (1 and 2). IN Programmable 1 AC Input 34Z5 U. P. S. RS232 2 3 5-20P OUT SITE WIRING FAULT 2 3 battery cabinets max TO BATTERY CABINET 72Vdc, 7Ah 344-50282-00 Pb BATTERY CONNECTOR Volt: 72Vdc 40A U. S. 6, 094, 363 AC Output Volt 120V~1O Hertz 50/60 Hz W/VA 1540W/1920VA Programmable WARNING AC Input Volt 120V~1O Amps 16A MAX Hertz 50/60 Hz 2 AC Output 1 2 3 5 4 6 8 9 10 4 5 6 Pulsar Evolution 3000 / 3000 XL 7 A 1 Data line protection R Programmable A IN OUT AC OUTPUT BRANCH PROTECTOR (15Amp max/plug) RS232 B 1 2 AC Output 34Z5 U. P. S. 8 AC Input B SITE WIRING FAULT WARNING 3 battery cabinets max for 3000 12 battery cabinets max for 3000XL 72Vdc, 9Ah Only for 3000 Pb TO BATTERY CABINET 344-50297-00 BATTERY CONNECTOR Volt: 72Vdc 40A U. S. 6, 094, 363 AC Output Volt 120V~1O Hertz 50/60 Hz W/VA 2000W/2800VA for 3000 2000W/2568VA for 3000 XL Programmable AC Input Volt 120V~1O Amps 24A MAX Hertz 50/60 Hz 1/2 2 L5-30 5-3 0P 9 10 1 2 3 5 4 6 7 8 9 10 Input power cords for connection to AC-power source; 2200/5-20P and 3000/L5-30. 11 Battery module connectors (to the UPS or to other battery modules). EXB additional battery module 11 3 11 13 12 Connectors for automatic detection of additional battery modules. 13 Circuit breaker for battery ON/OFF and protection. Page 8 - 3400723100/AD 1. Presentation 1. 3 Control panel 15 Illuminated ON/OFF button for the receptacles. 16 Operation on battery power. 19 Group 1 programmable receptacles supplied with power. 1 2 20 Group 2 programmable receptacles supplied with power. 21 Booster or fader mode. % 22 Bar graph indicating percent load at output. % 23 Bar graph indicating the battery charge level. 76 to 100%. 0 to 25%. 3400723100/AD - Page 9 2. All the connected equipment is supplied with power. 15 16 17 1 2 % % 1 2 % % Page 16 - 3400723100/AD 3. Operation 3. 3 Operation on battery power (following failure of AC-input power) Transfer to battery power The AC-input power is out of tolerances, LED 16 goes ON. During operation on battery power, the buzzer beeps every ten seconds. The equipment connected to the UPS is supplied by the battery. 16 1 2 % % Threshold for the low-battery warning When the threshold is reached, the buzzer beeps every three seconds. The low-battery warning threshold can be set by the user, with the "UPS Driver" software. There is very little remaining battery backup time. Close all applications because UPS automatic shutdown is imminent. When the battery reaches the end of its backup time, the UPS shuts down and all the LEDs go OFF. % 16 1 2 % The equipment is no longer supplied with power. The UPS automatically restarts when power returns. NOTE: If the UPS does not restart, check that the "automatic restart when power returns" function has not been disabled (see section 3. 4 Personalization). 3400723100/AD - Page 17 3. Operation 3. 4 Personalization (optional) Function Personalization parameters can be set and modified using the UPS Driver software installed on a computer that is connected to the UPS (see section 2. 5 Connection to the RS232 or USB communications port). Check that the RS232 26 communications cable is connected. [. . . ] Press the two parts of the battery connector tightly together to ensure proper connection. Page 22 - 3400723100/AD 5. Environment This product has been designed to respect the environment: It does not contain CFCs or HCFCs. UPS recycling at the end of service life: NOKIA UPS SYSTEMS undertakes to recycle, by certified companies and in compliance with all applicable regulations, all UPS products recovered at the end of their service life (contact your NOKIA branch office). Packing: UPS packing materials must be recycled in compliance with all applicable regulations. WARNING: This product contains lead-acid batteries. Lead is a dangerous substance for the environment if it is not properly recycled by specialized companies. Web site: www. mgeups. com 3400723100/AD - Page 23 6. Appendices 6. 1 Technical data Simplified diagram Filter Booster / fader transformer Input Output Inverter Charger Battery Page 24 - 3400723100/AD 6. [. . . ]