User manual NOKIA THR880I

[. . . ] User Guide 9239142 Issue 1 EN DECLARATION OF CONFORMITY We, NOKIA CORPORATION declare under our sole responsibility that the product Nokia THR880i is in conformity with the provisions of the following Council Directive:1999/5/EC. A copy of the Declaration of Conformity can be found at http://www. nokia. com/phones/declaration_of_conformity/. Copyright 2004-2005 Nokia. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. [. . . ] If is displayed, the loudspeaker is in use. To deactivate or activate the loudspeaker, press . If the call is a one-way call, you can also answer it by pressing and holding the PTT key. To end the call, press or . Mute the ringing tone To mute the ringing tone, press Silence. Reject a phone call To reject an incoming call and to send the caller the line busy tone, press Reject. Direct mode Basics In the direct mode, the radio operates without the network, so that the radios communicate directly with each other. The direct mode enables one-way calls both in the network coverage area and outside the network coverage area. For details and availability, contact your service provider. When the direct mode is active, only those radio functions that do not require the use of the network can be used. In the direct mode, you cannot send or receive status or text messages, make or receive network mode calls, use the Web browser or the data connection, or activate fast menu items that require the use of the network. To use radio functions that require the use of the network, activate the network mode, and return to the network coverage area. Your radio has direct mode channels, and each channel can have up to three groups. To receive a direct mode call that is made to the selected or a scanned group on the selected channel, the user must be in the coverage area of the transmitting radio. The radio coverage areas of different users can vary; even if you can hear a conversation, not all those speaking can necessarily hear you. For communication to be efficient, all the users should be within each other's radio coverage areas. Copyright 2005 Nokia. All rights reserved. 65 Start direct mode communication Activate direct mode To activate direct mode, select MenuSettingsPhone settingsActive modeDirect. To return to the network mode, select Network. When you activate the direct mode, the selected channel and group are those that were last selected in the direct mode. When you return to the network mode, the selected folder and group are those that were last selected in the network mode. When the radio operates in normal direct mode, Direct mode is displayed in the standby mode, and is displayed during direct mode calls. The names of the selected channel and group are shown on the display. The bar above indicates the signal strength of the radio you are receiving communication from. The higher the bar, the stronger the signal, and the better the connection. [. . . ] Observe restrictions on the use of radio equipment in fuel depots, storage, and distribution areas, chemical plants or where blasting operations are in progress. Areas with a potentially explosive atmosphere are often but not always clearly marked. They include below deck on boats, chemical transfer or storage facilities, vehicles using liquefied petroleum gas (such as propane or butane), and areas where the air contains chemicals or particles such as grain, dust or metal powders. Emergency calls Important: Wireless phones, including this device, operate using radio signals, wireless networks, landline networks, and user-programmed functions. Because of this, connections in all conditions cannot be guaranteed. [. . . ]