User manual NOKIA WIRELESS AUDIO ADAPTER AD-5B

[. . . ] Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice. The availability of particular products may vary by region. Please check with the Nokia dealer nearest to you. [. . . ] You only need to pair each individual headset once. Attach the Nokia Wireless Audio Adapter into the Pop-Port connector of your phone. Note that your phone should be in standby mode, ready to use, and it should not have any characters keyed in. The adapter blinks once briefly in green to indicate that the power is on. If the adapter has not been paired with any headsets, the state is indicated with a slow, continuous red blink. Note that if you have the keylock of your phone on, the keylock is automatically deactivated after you have attached the adapter into the phone. Note also that if you have the Silent profile on in your phone, the automatic answering does not work. Also Lights off mode in your phone should be activated, because having the lights continuously on reduces the battery life. 7 English Getting started Pairing the device Switch on the headset power before you start to pair your headset with the Nokia Wireless Audio Adapter. Make sure no other headsets or other compatible audio devices are active within a 10 metre range. Check the headset user guide to familiarise yourself with how to pair your headset . Attach the adapter to the Pop Port connector of your phone. Select the PIN entry mode by pressing the Control key once in the Wireless Audio Adapter to make the adapter find the compatible headset. If there are no headsets with compatible Bluetooth wireless technology within a 10 metre range, the light indicator blinks red to indicate an error situation. The adapter then goes into Init mode and blinks slowly a red light. See "Modes of the light indicator" on page 10. If a compatible headset is found, the light indicator of the adapter is continuously green for 20 seconds. Key in your four-digit Bluetooth passkey on the phone to pair the headset in this time period. The Bluetooth passkey is marked on the card that is provided in the sales package of the headset. If the pairing is successful, the phone display is cleared. The light indicator on the Nokia Wireless Audio Adapter is turned off and appears on the phone display. 8 Getting started The headset whose passkey you enter first becomes the default device for the Wireless Audio Adapter. The Wireless Audio Adapter and the headset are now ready to be used. Note that all audios, including the call alert tones, are now routed to the headset. [. . . ] Note that when the audios have been transferred to the headset, all audios including the call alert tones are routed to the headset. 12 Getting started If, during a call, the adapter is accidentally disconnected from the Pop-Port connector or the headset battery runs flat, the call is transferred to the phone and is continued normally. The pairing information stays stored in the permanent memory of the adapter. · Do not attempt to open the device. · Do not drop, knock or shake the device. [. . . ]